How do you program a key remote for a 2002 Isuzu axiom?

Answer 1

I found these at: http://www.programyourremote.com/classified/BrowseMake.asp?cid=59 # Open the driver's door.

# Insert key into ignition.

# Turn the ignition switch to the ACC position and then to the LOCK position three times. (This step must be completed within 3 seconds - go as fast as yo can, or the system will not enter the programming mode.)

# Within 10 seconds, close and open the door two times.

# Turn the ignition switch to the ACC position and then to the LOCK position three times (again, do this within 3 seconds.)

# Within 10 seconds, close and open the door. Verify that the power door locks cycle once to confirm that the system is in programming mode.

# Within 20 seconds, press the LOCK button on the transmitter you are programming. Verify that the door locks cycle once.

# Within 20 seconds, press the UNLOCK button on the transmitter. Verify that the door locks cycle once to confirm that the system has accepted the transmitter's code.

# Repeat steps 7 and 8 for each transmitter to be added.

# Remove key from ignition. Disclaimer