1.Make sure you have all the remotes you will use for the car. Once you enter program mode you will erase all existing remotes. 2.With your key in your right hand close and lock all the doors using the driver's power lock switch. 3.Within 10 seconds put the key in and out of the ignition 7 or more times. This can be a little tricky. Make sure the key comes all the way out of the lock and try using a rythmic pattern. Once you see the turn signal indicators flash twice turn the ignition to ACCESSORY. You're now in the program mode. 4. Press any button on the 1st remote. The turn signal indicators will flash indicating the remote signal has been accepted. 5. Unlock and lock the door locks using the driver's door and press any button on the second remote. Repete this step for up to 5 remotes. 6. Take the key and open the door. Your remotes should work.
This does work but takes patience since the process must be followed exactly. If you can't seem to get it done go to your local Nissan Dealer. Any decent service advisor should be able to do this for free. If they won't find another dealer!
you can go to best buy
if it has power door locks then it should have keyless remotes
how do you do this
http://www.nissanpathfinders.com/remotes.htm Nissan Pathfinder lost remote or new remote. How to program or reprogram the Pathfinders Remote control.seat is a box which is the sensor for the remote...........Go to this page and it will tell you how to do it.P.S. you can buy remotes online at e-bay
You can probably program your Comcast remote to work with it just fine.
Try looking in the owners manual, If not, try phoning the manufacturers customer service
try following instructions @ www.programyourremote.com
this a lot of bs, please unsubsrcibe me from your site.
To disarm the alarm on a 2001 Nissan Sentra without the remote, you can try inserting the key into the driver’s door lock and turning it to the unlock position twice. If that doesn't work, you can disconnect the car battery for a few minutes to reset the alarm system. Alternatively, you may need to locate the alarm's fuse and remove it to disable the system temporarily. Always consult the vehicle's manual for specific instructions related to the alarm system.
You can find a car remote replacement at BrentwoodAudioCar online. In order to get a replacement you need to provide them with the FCC ID number on the back of the remote.
To program a replacement remote for a 2001 Volvo S60, first, sit inside the car with all doors closed. Insert the key into the ignition and turn it to the "On" position without starting the engine. Press and hold the "lock" button on the new remote for about 5 seconds, then turn the ignition off. The remote should now be programmed and ready to use. If this doesn't work, consult the vehicle's manual or a professional for assistance.
how do you program your remote