1.Open the driver's door.
2.Insert key into ignition.
3.Turn the ignition switch to the ACC position and then to the LOCK position three times. (This step must be completed within 3 seconds - go as fast as yo can, or the system will not enter the programming mode.)
4.Within 10 seconds, close and open the door two times.
5.Turn the ignition switch to the ACC position and then to the LOCK position three times (again, do this within 3 seconds.)
6.Within 10 seconds, close and open the door. Verify that the power door locks cycle once to confirm that the system is in programming mode.
7.Within 20 seconds, press the LOCK button on the transmitter you are programming. Verify that the door locks cycle once.
8.Within 20 seconds, press the UNLOCK button on the transmitter. Verify that the door locks cycle once to confirm that the system has accepted the transmitter's code.
9.Repeat steps 7 and 8 for each transmitter to be added.
10.Remove key from ignition.
DID YOU TRY CHANGING OUT THE BATTERIES ON THE REMOTE??
bypass key on a trooper
To program a keyless entry remote for an Isuzu NPR 200, first, ensure that all doors are closed and the vehicle is in the "Off" position. Insert the key into the ignition and turn it to the "On" position (not starting the engine) and back to "Off" twice, ending in the "Off" position. Press and hold the lock button on the remote for about 10 seconds until the doors lock and unlock, indicating successful programming. Repeat this for any additional remotes, then turn the ignition to "On" to exit programming mode.
Isuzu Trooper was created in 1981.
1999 Isuzu trooper
timing marks for 1996 Isuzu trooper
The 6VE1 3.5L V6 fitted to the Isuzu Trooper was manufactured in-house by Isuzu themselves
The trooper is made by Isuzu
Remove Camshaft fro isuzu trooper 1996
will a 3.2L 2000 Isuzu Trooper engine fit a 3.2L Isuzu rodeo transmission
The sister vehicle of the Isuzu Trooper is the Acura SLX
Where is the fuel cut of switch for a 03 isuzu trooper