answersLogoWhite

0

You MUST take the vehicle to a professional (dealer or locksmith). You cannot just buy a "transponder" key online and program it yourself (like you can for a number of domestic vehicles) for a Nissan. It sucks, it's expensive (about $200 in my case), but that is how it is.

User Avatar

Wiki User

13y ago

What else can I help you with?

Related Questions

2000 Nissan Altima - How do you register second transponder key in the security system?

Requires special programming by dealer or locksmith. Locksmith is cheaper.


Which fuse controls the headlights in a Nissan Altima?

The tail light fuse controls the headlights in a Nissan Altima. A second fuse box is located next to the battery.


Where can one buy a Nissan Altima 2008?

The car model of the Nissan Altima 2008 can be found on many on-line second hand car stores as well as some approved dealers. It can be found on sites such as Auto Trader.


What causes hard shifting from low to second gear in my 1995 Nissan altima automatic transmission?

Check the transmission fluid on the 1995 Nissan Altima. Bad fluid can cause the transmission to shift harder on parts that are more worn.


Where is cylinder number 3 on a 2006 Nissan Altima?

Looking at the front of the car, number three will be the third from the left or the second from the right.


Does 2005 Nissan altima 2.5L 4-cylinder have timing belt or chain?

It has two chains the second being for the oil pump


Where is the second oxygen sensor located in a 2001 Nissan Altima gxe?

1 is on the intake manifold and the 02 sensor is right befor your cataylic converter


Is it normal to unlock your car with the key and the front windows come down if you hold the key for a second on a 2005 Nissan altima?

Yes yes yes this is normal since 99......


How you can find fuse box on Nissan altima 2006?

There are two, one is located under the hood to the left of the battery. The second is located inside the vehicle at approximately 7 o'clock in relation to the steering wheel.


How do I program a transponder key for Jeep liberty if you have two keys?

To program a transponder key for a Jeep Liberty using two existing keys, start by inserting one of the working keys into the ignition and turning it to the "On" position without starting the engine. After about three seconds, turn the key back to the "Off" position and remove it. Repeat this process with the second key, and then insert the new key you wish to program and turn it to the "On" position. Leave it in the "On" position for about 10 seconds; once done, the new key should be programmed.


How do you program 2006 Toyota 4 runner transponder key?

To program a transponder key for a 2006 Toyota 4Runner, you'll need two working keys. Insert the first key into the ignition and turn it to the "On" position without starting the engine. After about 15 seconds, turn the key back to "Off," remove it, and insert the second key, repeating the process. This will program the new key, and you should hear the locks cycle to confirm successful programming. If you don't have two keys, you may need to visit a dealership or a locksmith for assistance.


Why would a Nissan Altima 1994 manual stall in the middle of traffic and be difficult to start and drive in first gear but not in second gear?

Because you can't drive a stick, and its a hard carto drive stickin and first is geared lower.