answersLogoWhite

0

Answer

Depends on the garage door opener you have. For the most part hold the button on the visor until it flashes fast, or slow, Just so you see the light change. Then hold the button on you garage door remote next to the visor until the light on the visor changes again. This should do it. Now if you have a rolling code garage door opener then you need to locate the learn button on the garage door opener motor. Press the learn button until it changes and then run to your car and press the visor button until you see the light on the garage motor hold steady. Good luck.

Also, try www.homelink.com

User Avatar

Wiki User

15y ago

What else can I help you with?

Related Questions

How do you program the garage door opener on a 1998 Lincoln Navigator?

some garage door motors have a switch or button on the motor that raises the door. This switch has to be turn to the program position. You will need to have the hand held garage door opener held about 2 inches from the opener on in the Navigator. 1. hold the button on the visor that you want to use for the for the garage until the light on visor changes. then press both the visor and hand held opener button at the same time. Pushing the the hand held about three time. I hope this works for you. It did for me.


How do you program the auto garage door opener buttons on the visor on 97 Sebring?

read your manual.


How do you program the sun visor remote control for a garage on a Lincoln LS?

How to program the sunvisor remote control for a garage on ls lincon


How to program garage door opener on Chevrolet equinox?

Chevy doesnt offer that option. Get a visor clip on unit...LOL!


What are the 3 buttons on the visor of a 95 Lincoln?

the buttons could be for the built in garage door opener... im not familer with that model but they were used at that time


What are the three buttons on sun-visor 2000 sebring convertible?

They are a garage door opener.


How do you program the sun visor remote control on a 2000 Lincoln LS?

To program the sun visor remote control on a 2000 Lincoln LS, first, ensure the vehicle is in the "Run" position without starting the engine. Then, press and hold the "Learn" button on the garage door opener motor unit until the indicator light turns on. Next, press and hold the desired button on the sun visor remote until the light on the motor unit blinks and then turns off. Finally, test the remote to ensure it operates the garage door correctly.


Where is the Garage door opener on 1999 Ford Explorer?

The garage door opener is attached to the sun visor above the driver. Three buttons in a row, first button on the left. It needs to be programed with the remote from your garage.


How do you program the visor garage door opener for a 2011 chrysler Town and country?

Instructions are included in the link below. Just fill out the info asked for and it will walk you through it step by step.


How do you program the garage door opener switch located on the visor on a 2008 Mercury Milan?

This information can be found in your owner's manual. If not call the toll free telephone # listed in your owner's manual for help.


How do you program garage door opener for 2000 Nissan maxima?

To program your on-board factory garage door opener on your Maxima's visor, you first have to press and hold the first and third (outer two) buttons down at the same time for about 15 seconds without letting them go. Then, the middle button's red light will start to flash. When this happens, let go of the two outer buttons and immediately get your original garage door opener and hold it right near your visor, aiming it right at the three buttons. Press and hold the middle button down for about 5 seconds while you simultaneously press and hold your original garage door opener's button down for this same amount of time (5 seconds). After this process is complete, wait a few seconds and you should now be able to use this middle button as your "new" garage door opener!


What is the light on the visor clip on a c6 corvette?

That would be the garage door opener or homelink , however you want to look at it! There you go!