answersLogoWhite

0

There's not much to it. Remove the ash tray and you will see two Phillips head screws. Once you take those out gently pull on the plastic you have loosened up and it will pop off. There are metal clips that secure it on the upper left and right sides. This will expose the screws holding the radio in.

User Avatar

Wiki User

13y ago

What else can I help you with?

Related Questions

How do you replace the wiper arm on a 2001 Nissan Xterra?

You'll need a wiper arm puller, pretty easy takes less than 5 mins to pull


How do you replace an air filter on a 2001 Nissan Xterra?

Pop the hood theirs a black box with some latches on the side, pop the latches lift the top and then pull the old air fliter out and lay the new one in there shut it and latch it back...


How do you remove a fuse on a 2001 Nissan Xterra?

There is a fuse puller located on the far right side of the fuse panel by the steering wheel. It is a black pincer looking device about 1.5 inches long. Just slip the clamp over the fuse and gently pull.


Where is the blower motor resistor located on a 2001 Nissan Xterra?

just behind the blower motor under the passanger side dash is a plug that is the risistor. two screws hold it in place. just remove the two screws and pull out. xterraparts.com has themm for about $19.


How do I get codes from a 02 Nissan Xterra without a code reader?

Follow this link. It explains how to pull the codes without a code reader. http://nissanhelp.com/diy/common/nissan_engine_codes_read_2.php


How do you change wiper blades on a 2001 Xterra?

The 2001 Nissan Xterra has the most common hook-end wiper arms. See sources and related links below for installation videos. Also, purchase the replacement blades first and there will be additional instructions/illustrations on the replacement packages. Locate and press the tab or button where the wiper blade is inserted into the hook of the wiper arm and pull wiper blade out of hook. You may have to rotate and flex the blade to make enough clearance for the hook to pass through.


How do you remove heater controls from a 2001 Xterra?

To remove the heater controls from a 2001 Nissan Xterra, first disconnect the negative battery cable to prevent electrical issues. Then, use a flathead screwdriver to carefully pry off the trim panel surrounding the heater controls. Once the trim is removed, unscrew the mounting screws holding the heater control unit in place, disconnect the wiring harness, and gently pull the unit out. Reinstalling is the reverse process, ensuring all connections are secure.


How you removal the radio from Nissan primera?

Undo the 2 screws at the bottom of the of the panel then pull the panel out by the 2 heater vents at the top, when its out there should be 4-6 screws around the radio, undo them all then pull the radio out slowly until you can disconnect the wires at the back.


Will your 2002 Nissan X-Terra pull your 4300 pound travel trailer?

Pulling the trailer is not a problem the issue is stopping it with the xterra. = ask yourself == Does trailer have brakes? Surge or electric will be needed.


Where is the fuse for the power side mirrors on the Nissan Xterra 2002?

that fuse is just below the lights dimmer control, pull the litle door comparment and you'll find that all fuses are label.


How do you change 2001 Xterra Relay flashers?

To change the relay for the flashers in a 2001 Nissan Xterra, first locate the relay in the fuse box, which is usually found under the dashboard on the driver's side. Remove the fuse box cover and identify the flasher relay, typically labeled in the diagram on the cover. Using a flathead screwdriver or your fingers, gently pull the old relay out and replace it with a new one, ensuring it is securely seated. Finally, test the turn signals to confirm that the new relay is functioning properly.


Will your 2002 Xterra pull your 4300 pound travel trailer?

I have a 2003 xterra 4 x 4 and I pull a 4,300 coachman travel trailer with it. It will pull the trailer provided that you have a weight equalizing hitch and trailer brakes. You have to pull the trailer with the automatic transmission out of over drive.