TAke it to auto Zone They will read the codes free.
96 on up you need a code scanner,you can take it to auto zone to have the codes read ,free of charge.
will a gear shifter fork plate on 89 ford f150 work on 96 ford f150
You need to have a diagnostic meter to read the codes, then book to tell you what they mean.
Many auto parts stores will read the codes for you for no cost if you purchase the parts needed for repairs from them.
Yes
I dont see why not. and long as everything matches. you should be ok
there's about 300-400. you need to be more specific. there are fault codes for the engine, transmission, air bag, anti-lock, body controller, etc, etc. a fault code is recorded by one of the computers and turns on a malfunction indicator to warn the driver of a problem.
I have the same enginr in my 96 f150 stock it did 295 on a dyno its an automatic!
To reset the diagnostic faults on a 1600 Astra 96 model, you typically need to disconnect the battery for about 10-15 minutes to clear the fault codes. Alternatively, you can use an OBD-II scanner to read and reset the codes directly from the vehicle's computer system. After reconnecting the battery or using the scanner, ensure to drive the vehicle to allow the engine control unit to recalibrate. Always refer to the vehicle's manual for specific procedures.
96 on up you need a scanner, you can buy 1 at the auto parts place for around 100.00 dollars. actron hand held scanner to retreive trouble codes.
I would replace the ignition module in the distributor. Also need to make sure the coil and wire is good too.
yes basicaly all f150s 80 - 96 are the same types of trucks yes basicaly all f150s 80 - 96 are the same types of trucks