with the lug wrench!
It keeps you from shifting out of park without first putting on the brake.
what you should do is bring it to your local Nissan dealer and have them remove it
The beep function on the remote may be deactivated. To reactivate, simultaneously hold both the lock and unlock button for about three seconds. The car should chirp and the lights flash.
To remove the door lock on a Nissan Pulsar, first, disconnect the car battery to ensure safety. Next, remove the door panel by unscrewing any screws and gently prying it off to access the inner mechanisms. Locate the lock assembly, disconnect any electrical connectors, and unfasten the lock using the appropriate tools. Finally, carefully pull the lock out of the door.
Pay the fine.
To turn off the alarm, you insert the the key in the drivers door lock and turn the key to the right two times.
Just hold down the lock and unlock buttons at the same time for about 5 seconds.
The 2006 Nissan door lock relay switch is located inside of the drivers side door. You will need to remove the door panel in order to access the door lock relay switch.
To remove the door lock from a 1985 Nissan Pulsar, first, disconnect the car battery to ensure safety. Then, remove the interior door panel by unscrewing any visible screws and gently prying it off to access the lock mechanism. Locate the retaining clip or screws securing the lock cylinder and disconnect the linkage attached to the lock. Finally, pull the lock cylinder out from the door.
Unfortunately, on 2005 Nissan Pathfinder there is no option like this. And there is no way to go around it. U can not turn this option ON - cs it doesn't exist :) As I've heard new 2008+ model have this option.
Get in the car, lock the doors. Insert the key and then remove the key. (Repeat this about 7 times) After about the 7th time you will see the lights flash. Hold down the lock button for a few minutes and then hit unlock key. It should unlock the care and the remote should be programmed.
To remove the ignition lock cylinder on a 1998 Nissan 200SX SE, start by disconnecting the negative battery terminal to ensure safety. Then, remove the steering column covers to access the ignition switch. Insert the key into the ignition and turn it to the "ACC" position, then locate and press the release pin on the ignition lock cylinder with a small tool while pulling the cylinder out. Finally, remove the cylinder and replace or service it as needed.