answersLogoWhite

0

pull all the knobs for your heater controls off, remove 2 Philips screws pull heater bezzel out (not off completely) then you can pull the radio bezzel off. remove screws and pull stereo out. infinity stereo the amplifier is under the drivers seat.

User Avatar

Wiki User

13y ago

What else can I help you with?

Related Questions

How to change Mitsubishi outlander brakes?

View "Basic Brake System" by following the link below for the 1st generation Mitsubishi Outlander from 2003 to 2006http://www.outlander.net.ru/Vitaly/CHASSIS/03/GR00003900-35A.pdf


Where can you find a radio wiring harness diagram for 2007 Mitsubishi Outlander without Rockford Fosgate Speaker and without Navigation System?

8750A143


How do you turn the radio on in the Mitsubishi outlander?

To turn on the radio in a Mitsubishi Outlander, first ensure the vehicle is in the "On" or "Run" position. Then, press the "Power" button on the radio or infotainment system, which is typically located on the front panel. You can also use the volume knob, which often doubles as the power control. If the system is touchscreen-based, you may need to tap the power icon on the display.


Where is o2 sensor bank1 sensor2 located on 2003 Mitsubishi outlander?

On a 2003 Mitsubishi Outlander, the O2 sensor bank 1 sensor 2 is located in the exhaust system, specifically after the catalytic converter. This sensor monitors the oxygen levels in the exhaust gases to help manage emissions and fuel efficiency. To access it, you typically need to lift the vehicle and may need to remove any underbody shields or components that obstruct access.


How do you remove stereo from 2004 Kia Sorento?

remove the aircon vent panels next to the system


Where is the audio auxiliary port on a 2009 Mitsubishi outlander?

The audio auxiliary port on a 2009 Mitsubishi Outlander is typically located in the center console area. It may be found near the front of the console, often alongside the USB port or below the climate controls. If your vehicle is equipped with a factory-installed audio system, refer to the owner's manual for specific details.


Where is the aux input jack on a 2015 Mitsubishi Outlander?

In the 2015 Mitsubishi Outlander, the aux input jack is located in the center console, near the front, typically next to the USB ports. You may need to lift the cover of the console or look in the storage compartment to find it. If you're using the vehicle's infotainment system, ensure the correct source is selected to use the aux input.


Where is bank 1 sensor 2 in a 2003 Mitsubishi outlander?

In a 2003 Mitsubishi Outlander, bank 1 sensor 2 is located on the exhaust system, specifically after the catalytic converter on the bank 1 side of the engine. This sensor monitors the level of oxygen in the exhaust gases to help manage emissions and fuel efficiency. To access it, you may need to lift the vehicle and work from underneath.


Does the 2007 mitsubish outlander have daytime running lights on it?

The 2007 model does have daytime running lights,But they may have to be programmed in by a Mitsubishi workshop. Not all countries have mandatory daytime running lights ,The system is part of the ETACS (electronic timing and control system ) and is only accessable via a dedicated Mitsubishi data tester.


Where is ac pressure switch located on 2003 outlander?

The AC pressure switch on a 2003 Mitsubishi Outlander is typically located on the high-pressure line of the air conditioning system. It is usually found near the condenser or the compressor. To access it, you may need to remove some covers or components, depending on the specific layout of your vehicle's engine bay. Always refer to a repair manual for detailed instructions and safety precautions.


On the new Mitsubishi Outlander 2007 can you use the hard-disk navigation system while actually using the radio erganomics to watch a movie or listen to stereo period?

Not sure I understand the question but u cannot use the dash mounted CD/DVD/mp3 disc slot to play a DVD when the car is moving but the sat nav works when the music server or radio is in use.


How do you disable drl on 2010 outlander?

To disable the Daytime Running Lights (DRL) on a 2010 Mitsubishi Outlander, you typically need to locate the fuse box and remove the fuse associated with the DRL system. Alternatively, some models may allow you to disable DRL through the vehicle's settings or by using a diagnostic tool. Always consult the owner's manual for specific instructions related to your model, or consider seeking assistance from a professional mechanic.