answersLogoWhite

0

The hood rod holders are held in place with rivets. You can remove the rivets with a small grinder. When the rivets are removed the fastener will come off.

User Avatar

Wiki User

10y ago

What else can I help you with?

Related Questions

How do you remove the grill from a 2002 Mercury Mountaineer?

Open the hood and remove the plastic trim fasteners along the top then detach the grille assembly by pulling upward


BMW 325i cabin filter where located?

It is located under the hood on the firewall. If you open the hood and look just below the windshield you will see a black plastic cover with 3 fasteners. Turn the three fasteners and they will pop up pull off the cover and remove the filter replace and reinstall the cover.


Where is ECM location on 2004 Altima?

On the 2004 Altima, the ECM is located under the hood. It is located around the under-hood relay and fuse box.


How do i remove a Toyota echo battery?

1) Open hood 2) Back off bolts holding fastening bar 3) Loosen positive and negative fasteners to battery 4) remove battery


How do you replace egr valve Nissan Altima 2000?

First you have to pop the hood, then look for the EGR valve. Once it is located, remove it and replace it with the new one. When finished, close the hood and you're good to go.


Where is cabin filter Pontiac torrent?

Under the black plastic just below the windshield, two of the fasteners will have to be undone before you open the hood, then there's more after you open the hood, remove plastic cover and the filter is right there. Good luck.


How do you remove the engine hood from a Massey Ferguson 60 HX?

To remove the engine hood from a Massey Ferguson 60 HX, first, ensure the tractor is turned off and secure. Locate and remove any bolts or fasteners securing the hood, typically found near the front and sides. Carefully lift the hood off, taking care not to damage any attached components or wiring. If necessary, consult the owner's manual for specific instructions related to your model.


Cable for the hood broke on Nissan altima 2005?

cable broke release latch for the hood can't open it


Are all of the fuses under the hood in a 1999 Toyota Solara?

No some are inside the car. On the drivers side on the left under the stearing wheel there should be a little coin holder. Remove the holder - the additional fuses are behind it.


How do you remove the passenger side headlight assembly on a 2000 Jetta Need to remove the whole assembly not just replace the bulb?

there are 4 screws that fasten the headlight assembly, 2 on top that are visible when the hood in open, and 2 on the bottom that cannot be seen at this point. Start by disconnecting the hood latch pull form the latch assy. next remove the grille to expose 5 fasteners that hold the bumper cover. there are 2 more behind the lower bumper air inlets(left and right side, 1 each). next there are 4 fasteners in each wheel opening (front portion) that go into the bumper cover, now you can remove the bumper cover and expose the 2 headlight lower fasteners.


How do you remove the front center grill in Chevy optra?

To remove the front center grill on a Chevy Optra, start by opening the hood and locating the screws or clips securing the grill to the front frame. Remove these fasteners using a suitable screwdriver or socket wrench. Gently pull the grill away from the vehicle, being careful not to break any clips. If it’s stuck, check for any additional hidden fasteners before fully detaching it.


Where is the throttle position sensor on a 04 Nissan altima 2.5 liter?

under the hood