from redlinegti.com
more on http://www.redlinegti.com/forum/vtk.18333.0.asc.removing+gear.20.htm
Now for the directions
Remove the standard knob
This simply pulls straight off (..interject something about straddling and tugging firmly...)
There is a plastic sleeve moulded over the end of the shift lever. The bottom of this is a flange which holds the gear boot up near the knob. There are three vertical ribs on this sleeve which stops the std knob from twisting.
If your replacement knob fits over this sleeve then all you need to do is follow the fitting instructions supplied and you're done.
If you have a MOMO or similar you will need the next step.
Removing the top of the plastic sleeve
-THIS IS NOT REVERSABLE ONCE YOU'VE DONE THIS YOU CAN'T GO BACK-
About 10mm from the bottom of the sleeve there is a groove around the shifter. Cut around the sleeve in this groove.
Carefully shave down the sleeve from the top removing the plastic from the metal shaft underneath. The shaft is knurled and may damage any blade you use. Don't dig too deep into the plastic as it's very thin and will shave off easily.
I removed two sides and then twisted the sleeve off with a pair of pliars.
To remove the gear knob on a 2006 Suzuki SX4, start by locating the small plastic cover at the base of the knob and gently prying it off. Then, use a wrench or pliers to loosen the nut that secures the gear knob to the shifter shaft. Once the nut is removed, pull the gear knob straight up to detach it from the shaft. Be cautious to avoid damaging any surrounding components during the process.
To remove the gear shift knob on the SLK 320, first pry the cover from the gear shift knob. Then, use a screwdriver to remove the screw in the center of the knob. This will then allow the knob to be removed.
How do you remove the gear shift knob on a 2000 Daewoo Lanos?
how to remove gear shift knob on bmw318
To remove the gear shift knob on the '03 Silverado, first pry off the cover that has the shift pattern on it. Then, remove the screw that is under that cover to remove the knob.
To remove a Vauxhall Movano gear knob, first ensure the vehicle is in neutral and turn off the ignition. Depending on the model, you may need to remove a plastic cover or trim around the base of the gear knob. Then, locate the retaining clip or screws securing the knob, if applicable. Finally, pull the gear knob straight upwards to detach it from the gear lever.
The gear shift knob on a ford Ranger is pressed on tightly. A heat gun or hair dryer can be used to heat the knob to help remove it.
twist the gear knob anti clockwise and it will come off
A vauxhall agila gear knob is hard to remove but to remove it you only need to pull it as hard as you can while twisting it then wank it will come off.
The knob just screws off.
Unscrew it from the shaft
dont