To remove the antenna mast from a 2002 Suzuki XL-7, first, locate the base of the antenna where it connects to the vehicle. Use a wrench or pliers to unscrew the retaining nut, then gently pull the mast straight out from the base. If the mast is stuck, you may need to apply some penetrating oil to loosen it. Once removed, you can replace it with a new mast or leave it off as needed.
remove inner fender passenger side antenna mast is right there back towards door you can get a new antenna for about 56 dollars
I removed the entire power antenna assembly and could not find any way possible to separate the mast from the motor assembly. Odd, since Mitsubishi sold me an antenna mast.
To change the antenna on an Infiniti G2 2002, locate the antenna base on the exterior of the vehicle. Unscrew the old antenna and disconnect it from the wiring. Attach the new antenna to the wiring and screw it into place on the antenna base.
Remove the luggage compartment side trim panel if the entire antenna assembly has to be replaced.With the antenna in the down position, remove the antenna mast nut. Do NOT pull the antenna mast up by hand. With the ignition key in the ON position, turn the radio ON to raise the antenna out of the motor.
You can get a new mast for the antenna from any Hyundai dealer. This happens a lot and they usually stock them. If you can get all of the old mast out, it's a rather simple procedure, although it can be tricky to get the antenna to grab the new mast. 1. Remove the nut holding the mast into the antenna (12mm I think). 2. Turn the radio on and pull the antenna mast out. There should be a round disc and a ball on the bottom. If not, you'll need to remove the antenna assembly and take the rest of the pieces out of the antenna. If the disc and ball are present, continue with step 3. 3. Push the plastic of the new antenna mast down into the antenna as far as possible. 4. Have an assistant turn off the radio while you're pushing the plastic into the antenna. 5. If the antenna does not grab onto the mast, return to step 2. Otherwise, continue with step 6. 6. Install and tighten the mast nut. 7. Turn the radio on. 8. Turn the radio off. Your mast should now be properly seated. 9.there is a plastic washer also inside that you will have to force the mast thru to get it the set in the motor ! if you cann't push thru , next step take out motor and remove the tube for antenna, you find in sitting inside make sure connect it back the same it is stting , after that replace in car, have someone turn and off radio,job done
You would need to get a tool to remove the notched chrome piece that holds the antenna mast, or carefully use pliers to unscrew it out. After you remove that, the antenna itself is held by a 10mm bolt. to get to it you'll need to open up the trunk lining near the antenna location and remove that bolt. Then, pull the antenna far enough to disconnect the antenna wire and power. Assuming the antenna motor is still functional, you can then replace the antenna mast with a new one. Or, you can install an aftermarket rubber antenna.
Begin by removing the wiring harness from the bottom of your antenna. Remove the antenna retaining nuts. Reverse the process to install your new antenna.
Begin by removing the wiring harness from your Volvo antenna. Remove the antenna retaining nuts. The antenna will come off. Reverse the process to install your new antenna.
Begin by removing the wiring harness from your 1994 Mercury Grand Marquis power antenna. Remove the power antenna retaining nuts. The power antenna will come off.
To replace an antenna mast, first, safely remove the old mast by detaching it from the mounting bracket and disconnecting any cables. Next, install the new mast by securing it to the mounting bracket and reattaching the cables. Ensure everything is tightly fastened and check for proper alignment. Finally, test the antenna signal to confirm successful installation.
if your antenna mast goes up and down when you tyun if on turn the radio off and it should go down if not remove the mast they just screw off the top if your antenna mast goes up and down when you tyun if on turn the radio off and it should go down if not remove the mast they just screw off the top
# Lower the glove box and disconnect the antenna cable connection # Remove the antenna mast # Loosen the right front wheel lug nuts and support truck on jackstand # Remove the right wheel and inner fender splash shield # Remove the antenna bas mounting bolt and detach the grommet and cable from the body then lower the assembly from the wheel opening