answersLogoWhite

0

Remove the four bolts on the bottom of the seat back and the 2 bolts on each headrest. Take out the headrests. Lift straight up.

User Avatar

Wiki User

10y ago

What else can I help you with?

Related Questions

How do you replace an alternator on a 1990 Acura Legend?

Remove the belt from your 1990 Acura Legend alternator. Remove the wiring harness from the back of the alternator. Remove the alternator retaining bolts. Reverse the process to install the new alternator.


Where is the factory amplifier for the radio located in a 1993 Acura Legend?

It's behind the back seat on the driver's side.


Where is the bulb for the instrument panel light in a 1995 Acura Legend?

You hav to remove the inst. cluster and them disassemble it (just remove the back plate) and you will find the bulb in there.


Where is the fuel filter on a 1993 Acura Legend?

inside the engine compartment on the drivers side back by the firewall next to the brake master cylinder and diaphram.


Where is the fuel pump of 1991 Acura Legend located?

under the back seat


How do you remove the front seat of a 1992 Acura Legend?

There should be four bolts under the seat, move the seat all the way back then take the front two out than move it all the way forward and remove the back two, after that unhook any wires there are connected


Where is the fuel pump in an 1990 Acura Legend?

the fuel pump is in the truck behind the back seat, 4 bolts to remove the cover, its on the left side six bolts to go and pull straight up.


How do you replace the back speakers in a 2006 Acura TL?

To replace the back speakers in a 2006 Acura TL, remove the SRS housing on both sides and the back panel of the speakers. Remove all wiring attached to the speakers and replace.


What causes water to leak at the back of an engine of 1993 acura legend?

Water leaking at the back of a 1993 Acura Legend engine can be caused by several factors, including a failing water pump, a damaged or worn radiator, or a leaking gasket. A faulty heater core or cracked hoses may also contribute to the issue. Additionally, corrosion in the engine block or a loose connection in the cooling system can lead to leaks. It's important to diagnose the source accurately to prevent engine overheating and further damage.


Locating the camshaft position sensor 1991 Acura Legend?

The camshaft position sensor on a 1991 Acura Legend is located at the back of the camshaft, near the rear bearing cap. It monitors the rotation of the camshaft and relays this information to the vehicle's computer.


I Need Wiring diagram for 89 Acura Legend?

Haynes Manuals Contain Wiring Diagrams in the back of the book.


How do you change the oil pan on a 1995 Acura Legend?

The oil pan on a 1995 Acura Legend is changed by draining the oil, removing the retaining bolts, and lowering it from the engine. The components are then cleans, a new gasket installed, and the pan bolted back in place.