I Don't know yet but I was thinking about doing this on my Corolla as I need to get windsurf gear into the car, and have removed the backseat on several other cars in the past for same reason. Will let you know when I have figured it out.
To remove the back seat of a 1998 Toyota Corolla, you will need to remove the carpet to expose the bolts for the seat. Then, loosen the bolts by removing the nuts. You can then remove the seat.
To remove the radio in a 1995 Toyota Corolla, first pry the radio frame from the dashboard using a flat tool like a screwdriver. Then, press in on the pins at each side of the radio and slide it out of the dashboard. Remove the wires from the back of the radio.
it is on the back of the seat. remove the seat and remove the black cover on the middle. the pump and the filter are together.
There are no clips...two screws on front...one nut on back...jiggle and pull...
To change the headlight bulb on a 1998 Toyota Corolla, first, open the hood and locate the back of the headlight assembly. Disconnect the power connector by twisting it counterclockwise, then remove the old bulb by pulling it straight out. Insert the new bulb without touching the glass, as oils from your skin can cause it to burn out. Finally, reconnect the power connector and test the headlight to ensure it’s working.
To replace a wiper motor on a 1994 Toyota Corolla, remove the rubber stopper that cover the hardware attached to the wiper arms. Then grab the wiper arm and jiggle it back and forth until it comes off. Remove the old one and slip the new one on.
To replace the speedometer cable in a 1998 Toyota Corolla, first, disconnect the negative battery terminal for safety. Remove the dashboard panel to access the speedometer, then detach the speedometer cable from the back of the speedometer by twisting it counterclockwise. Next, locate the other end of the cable at the transmission, disconnect it, and install the new cable by reversing the removal process, ensuring it is properly connected at both ends. Finally, reassemble the dashboard and reconnect the battery.
6.5 or 6.75 will work, 6x9 wont unless you modify the back with cutting and customizing the grills. 6.75 are a perfect fit
Take it back and get them to check it.
first you need to remove the door sill plastic panels, just lift them right up and then pull the kick panel plastic back towards the B pillar that should remove them
is your toyot a saloon or estate and what year
4 x 4.5"