answersLogoWhite

0

on the passenger side of the car, under the glove box, you should find a trim panel to the right. there is a small plastic nut holding the panel to the firewall. remove this panel and you will find the vehicles computer. where the plastic nut for the panel was, there is a 10 mm nut holding the computer to the firewall and 2 other screws holding the computer to the fender area.

after removing these, you can move the computer out, without unplugging it from the vehicle. now you should be able to see where the blower is. there will be 2 yellow wires with plugs attached to the the blowers housing. unscrew these screws and move the wires out of the way. there will be another plug going up toward the firewall from under the glove box. do not unplug it. i did and now my airbag light keeps flashing (still working on how to fix that one). you will find a small plug in the side of the blower houseing. unplug it and move out of the way.

once this is done you should be able to see 4 screws around the blower housing. use a Phillips head screwdriver and remove them. the blower moter, and fan should fall onto the floor (so watch your head).

i thought my blower was bad, but found that there was a piece of foam inside the blower housing that had been caught in my fan. i removed this foam, put some fan oil in all the spots i could in the motor and now my blower works better than ever.

hope it works for you

User Avatar

Wiki User

13y ago

What else can I help you with?

Related Questions

Where is blower motor 2010 Nissan rogue?

where is the blower motor on a nissan rogue


Where is the Blower motor on a Nissan Sentra?

The Nissan blower motor can be found in the engine compartment on the firewall. The blower motor will be on the passenger side of the firewall.


Will a motor from a 1998 Nissan 240sx fit a 1995 Nissan 240sx?

Yes. The ka24de motor is used from 95 through 98.not just used from 95 to 98 because i have a 1990 240sx with a ka24de in it


Where is the blower motor resistor on the nissan xtrail?

remove the cover under the glove box and you will find it to the rear and right of the blower motor held in by two screws


How do you replace a blower motor on a 2000 Nissan Maxima?

* Disconnect the negative battery cable * Remove the glove compartment and lower dash trim to gain access to the heater case and blower motor * Detach the blower motor cover and disconnect the electrical connector from the blower motor * Remove the blower motor mounting screws and pull the blower motor carefully out of the housing * If you are replacing the motor detach the fan and transfer it to the new motor


Will a motor from a 98 Nissan 240sx fit a 95 Nissan 240sx?

yes it will with the correct engine mounts, cross member and loom


Nissan Quest blower motor?

The Nissan Quest blower motor is located on the firewall in the engine compartment. The blower motor can be found on the passenger side of the engine compartment.


How do you replace Ford Focus blower motor?

Remove the blower motor retaining nuts. Remove the wiring harness from the back of the blower motor. Remove the fan from the blower motor. Reverse the process to install the new blower motor.


How do you replace the blower motor on 1978 Ford 350 Truck?

Remove the wiring harness from the back of the blower motor. Remove the blower motor retaining screws. Remove the fan from the blower motor. Reverse the process to install the new blower motor.


How you change the blower motor resistor in Nissan maxima 2002?

To change the blower motor resistor in a 2002 Nissan Maxima, locate the blower motor resistor under the glove compartment on the passenger side of the vehicle. There is a clip that is depressed and then the resistor will slide out. Remove both ends of the resistor and then replace with the new resistor.


How do you take out the blower motor in a Nissan Versa 2009?

1. Remove the instrument panel and pad. 2. Remove the right side ventilator duct. 3.Disconnect the blower motor connector. 4. Push the flange holding hook toward the blower motor, then rotate the blower motor clockwise and remove it from the A/C unit assembly. 5. Installation is the reverse of removal, noting the following: 6. Rotate the blower motor until the blower motor flange holding hook locks securely in A/C unit assembly.


How do you change blower motor on 2001 corvette?

Remove the wiring harness from the back of your 2001 Chevrolet Corvette blower motor. Remove the blower motor retaining bolts. Remove the blower motor fan. Reverse the process to install the new blower motor.