Do the following to remove the brake drum on 1995 Isuzu Pickup.
- Remove wheel from the brake drum- Remove the Philips screw that holds the brake drum to the axle plate.
The brake drum is now free to be removed but is usually stuck to the lug bolts.- spray penetrating oil on the lug nuts (be sure to put card board below wheel to catch the oil that will run off.- Use a plastic hammer and hammer the drum off the axle plate.
- An alternate way is to place a 2 x 4 across the top of the lug nuts and use two c-clamps to pry the drum off the lug nuts.
19 gallons
on your brake pedal lever.
To remove the glove box from a 1995 Isuzu pickup, first, open the glove box and empty its contents. Next, locate and remove the screws securing the glove box to the dashboard—typically found along the top and sides. Once the screws are removed, gently pull the glove box towards you to detach it from the hinges. Be cautious of any wiring or clips that might be attached and disconnect them if necessary.
On a 1995 Isuzu pickup, the turn signal flasher is typically located under the dashboard, near the steering column. It is usually found in the fuse box area or attached to the steering column itself. To access it, you may need to remove a cover panel or kneepad. Always refer to the vehicle's service manual for the exact location and instructions.
you pull it out
on brake pedal lever.
which one the center or the side?
Remove the tire and wheel from your 1995 Chevy. Remove the brake assembly. Tap on the brake rotor with a mallet or hammer. The brake rotor will slide off.
Remove beltUnbolt tensioner and remove
HIT IT WITH A MALLEt
Remove the tire and wheel from your 1995 Chevrolet K 3500. Remove the front brake assembly. Tap on the brake rotor with a hammer or mallet until it becomes loose. Slide the brake rotor off.
Remove clamp that holds the rode on back of brake booster that hooks to the brake peadle. Then remove the two nuts on the brake booster that holds the mastercylender on the in the inside of truck remove the 4 nuts/bolts that hold the brake booster on then remove brake booster then replace with new one.... P.s. Make sure u pump brakes b4 u move vehicle........ U shouldnt have to bleed brakes unless u undo mastercylender