0
It's very easy, the only tool you need is a Phillips head screwdriver.
1. flip up the center console and pull the emergency brake handle, then pull up on the black plastic cupholder, it helps using a hand inside the e-brake pocket -- it just snaps right out.
2. pull up on the woodgrain/plastic piece surrounding the gear shift -- also just snaps right out
3. pull the woodgrain/plastic dash piece starting at the bottom -- yes, it too snaps right off, BUT, it has many wires attached that you DO NOT need to remove. Just push the unsnapped dash piece to the right a bit and you'll have plenty of room to work.
4. Use your Phillips head sd to unscrew the 4 screws holding the radio in place and pull out the radio! voila!
What else can I help you with?
How do you remove the stereo on a 1995 Dodge Caravan?
You have to remove the vent & bezel assembly from below the radio first, then the entire dash bezel from around the instrument cluster & radio.
How do you change car sterieos?
To change car stereos, you will need to remove the bezel or cover from the stereo in the vehicle. Then, pull the stereo out of the dashboard and remove the wiring harness. You can then attach the new stereo to the harness.
Removal of 1993 Nissan 240 sx stero radio?
Pull the shifter bezel out near the ash tray, and carefully pop the bezel out from around the stereo. The 4 screws around the stereo will remove it.
How do you remove the dash to get at the stereo?
According to my Haynes manual all you have to do to get at the stereo is remove the center bezel. that is the plastic panel covering the area around the stereo and the climate controls. just grip the plastic between the radio and the climate control panel and pull. make sure to unplug the electrical connector for the courtesy light before you fully remove the bezel.
How do you install a headlight on a 91 Toyota Tercel?
you must remove the grill and the bezel that surrounds the light.
How do you replace radio on a villager?
To replace the radio on the Villager, first remove the bezel from around the radio by prying it from the dashboard. Then, squeeze the clips on either side of the radio to remove it from the dash. Disconnect the wires and attach them to your new stereo. Then, replace the clips and the bezel.
How do you remove stereo T5 VW Transporter?
Remove the plastic bezel from around the stereo Locate the removal key insertion slots/holes. slide in the removal keys until they lock pull firmly and the unit should slide out of the mounting sleeve.
How do you remove the stock radio on a 2003 tiburon?
push open the ashtray to give yourself room to fit a flathead screwdriver to the bottom left of the bezel, do not remove the ashtray. pry up the bottom left part of the bezel, then the bottom right, then the middle left, then the middle right, then the top left, and finally the top right . the bezel should come right off. remove the five connectors attached to the bezel by pushing down on the taps and pulling them out. next remove the four Phillips head screws at each corner of the stereo. pull out the stereo and remove the wiring harness by pushing down on the tab and just pull out the single black antenna wire.
How do you remove radio from 2002 Kia Optima?
Open your ashtray grip your fingers under the black bezel that raps around your stereo and AC controls. Now pull bezel from where your ashtray is it will pop out then work your finger in to the top there are 4 clips that hold it in place 2 on the bottom and 2 at the top left and right side be gentle with it. There is no screwdriver needed to remove bezel but you will need a phillips driver for the stereo. This is for a 2002 KIA OPTIMA. Mine is a SE V6
How do you remove stereo from a 1998 dodge stratus and install new one either single din or double din?
Using a standard screwdriver (thin blade), pry the bezel around the stereo away from the dash until you're able to pull it away (it snaps back in). Once the bezel's been removed, there are two bolts that hold the stereo in. Remove those, disconnect the antenna and wiring harnesses, and the old stereo is out. Installation of the new one depends on the model/size you're purchasing.
How do you remove a radio on a 2000 Toyota Tacoma?
You need to remove the two screws above the climate controls. Then you pull the bezel around the radio off the dashboard. Next, you unscrew the four screws holding the deck to the dashboard and pull out the stereo and twist it so you can see the backside. Finally, you unplug and pull out all of the wiring.
How do you remove the dashboard to get to lights on a 1997 Toyota Corolla?
you don't! remove bezel for gauges, remove four screws for gauge assembly, pull forward and tilt, replace the four bulbs.
