remove the screws. make sure you don
Remove the plastic cover going around the board. It sits on clips. After you will see 4 screws holding the board. Remove them too. Pull out carefully the board, disconnect 3 wire harnesses.
In the trunk. Under the wooden board.
To remove the dashboard from a Mitsubishi Eclipse, first disconnect the negative battery cable to ensure safety. Then, remove any trim pieces and screws securing the dashboard, which may include the instrument cluster and air vents. Carefully pry off the dashboard, being mindful of any electrical connections, and disconnect them as you proceed. Finally, lift the dashboard out of the vehicle, ensuring all components are free.
car manual
It depends. if you have a eclipse that was made by chrystler then it is the one box deep behind the radio mounted on the floor board. it looks like an ecu but chrystler put that under the hood. If its a Mitsubishi made eclipse then the ecu is right beside the tcu behind your radio. the tcu in the Mitsubishi made car is to the right on the pasengers side.
Trouble code P0403 means: EGR Control Solenoid Circuit Malfunction
In order to replace the rear engine mount on a 2001 Mitsubishi Eclipse Spyder GT v6 3.0L, one would first need to acquire a few jack stands to help accommodate the steps involved. From there, the Eclipse Chat Board would need to be lifted off, and the mount can be replaced from then on.
The red battery warning light is an indication the charging system is not charging. The red water level warning light is an indication additional water is needed.
Eclipse and Enchanted Forest are board games.
the pcm is under the dash board in the middle tha passenger side and driver side remove the 2 plastic caps and will be a black boox with 4 connections
Sounds like the water thermostat is stuck open. That causes the ENGINE to heat up very slowly.
breaker yard