answersLogoWhite

0

If its like on my 2009 sorento,you have one bolt on the lower left side on top to remove,then just pull on each corner,can be hard on the first time.

There are six Phillips screw heads that are 10mm socket(i believe) you can use either to remove but the socket will be less likely to slip and damage the hardware. There are two nearest the firewall, two around centerline and two nearest the grill. Careful not to drop them. The two at the bottom are most likely to be lost so magnetic style screw driver or magnetic sockets would be best, while the top four can be left in place when loosened. Then clean around the oil filler cap as best as possible to eliminate the possibility of junk getting in the oil fill. Remove cap once clean, pull up evenly on the engine cover and gently, it will pull up and out. Hope that helps.

User Avatar

Wiki User

13y ago

What else can I help you with?

Related Questions

What size engine does the 2005 Kia Sedona have?

The 2005 Kia Sedona has a V6 engine.


What is the base engine size of the 2005 Kia Sedona?

The 2005 Kia Sedona has a 3.5 L base engine size.


How many horsepower does the engine in the 2005 Kia Sedona have?

The 2005 Kia Sedona's engine produces 195 hp @ 5500 rpm.


How much torque does the engine in the 2005 Kia Sedona have?

The 2005 Kia Sedona's engine produces 218 ft-lbs. @ 3500 rpm.


Where is camshaft sensor on 2005 Kia Sedona?

The camshaft sensor on a 2005 Kia Sedona is typically located near the front of the engine, on the cylinder head. It is generally positioned near the timing cover, often on the driver's side. To access it, you may need to remove some engine covers or components, depending on the specific setup of your vehicle. Always refer to a repair manual for detailed instructions and diagrams.


How do you replace a thermostat on a 2005 Kia Sedona?

To replace the thermostat on a 2005 Kia Sedona, first ensure the engine is cool, then disconnect the negative battery terminal. Remove the engine cover and locate the thermostat housing, typically near the engine block. Drain the coolant, unbolt the housing, and take out the old thermostat, replacing it with a new one while ensuring the gasket is seated properly. Reassemble everything, refill the coolant, and reconnect the battery.


Where is the thermostat on 2005 Kia Sedona?

The thermostat on a 2005 Kia Sedona is located on the top of the radiator. To access the thermostat, you will need to remove the upper hose assembly.


How do you remove the plastic engine cover from a 2005 Cadillac SRX?

To remove the plastic engine cover from a 2005 Cadillac SRX, first, locate the retaining bolts or clips securing the cover. Use a socket wrench to remove the bolts or carefully pry off the clips with a flathead screwdriver. Once the fasteners are removed, gently lift the engine cover straight up to detach it from the engine. Be cautious not to damage any underlying components during the removal process.


What is the firing order for a 2005 Kia Sedona?

It helps to know the engine firing order, when trying to figure out engine problems. The firing order of a 2005 Kia Sedona is 1-2-3-4-5-6.


How do you remove the engine cover on a 2005 Cadillac Catera?

well not for how but cadillac cateras were only made from 1997 to 2001


How do you remove the decorative cover on a 2005 Crossfire engine?

Simply pull up on the engine cover it is held in by four clips i believe. The cover with pop off with little strength used to pull it out of the clips . Then slide it towards the windshield to remove the air intake hoses. BK


Where is the oil pump in 2005 Chevy Silverado?

It is in the front of the engine behind the timing cover. Not in the oil pan. You will have to remove the front of the engine to get to it. Tough Job