take a look at this site: http://www.scosche-cars.com/encyclopedia/ta891.pdf?userID=374e630d46e5d9fc5814b7baca687048&vehicle_id=TA0342 Good luck, Minh
See below-
toyota avensis 2004 how to remove door panel from passanger side front door
how to remove 2012 fortuners front door pannel
To remove the dash panel in a Toyota Highlander, start by disconnecting the negative battery terminal for safety. Then, carefully pry off any trim pieces surrounding the dash panel using a trim removal tool to avoid damage. Unscrew any visible screws securing the panel and gently pull it away from the dashboard, being cautious of any clips or connectors attached. Finally, disconnect any electrical connectors if necessary to fully remove the panel.
Remove the dash or cut the front panel out - its the most annoyng job ever. Easier to change the engine...
remove the screw in the door handle get a pry bar flat and insert it on the side top part and pop it open ,remove the top ,remove three screws that hold the bottom portion of the panel { it;s a two part panel} then pry the rest of the panel out that it...
remove small cap in top right corner of gear indicator panel. depress small button and shift
remove front door panel 1995 Nissan maxima
To remove the door panel on a 2003 Toyota 4 Runner, locate the screws holding the panel to the door. Unscrew these and lift the panel up and away from the door.
haw to remove front door panel vw sharan 2004?
The only tools need to remove the inside door panel on a Toyota Sequoia is a screwdriver. There are various crews that need to be taken out to remove the door panel. After the screws are out, the door panel comes off very easily.
To replace the right taillight assembly on a 2012 Toyota Highlander, first, open the rear hatch and locate the access panel on the inside of the cargo area. Remove the panel to expose the taillight assembly screws, then unscrew and disconnect the wiring harness from the old taillight. Replace it with the new assembly by reconnecting the wiring harness and securing it with the screws, then replace the access panel. Finally, test the new taillight to ensure it’s functioning properly.