0
Remove the wheel and the brake caliper. Remove the two 18mm bolts that hold the brake caliper bracket, and remove it and the rotor. Remove the small bolt that holds the antilock brake sensor and remove the sensor. Remove the 32mm axle nut. The nut may be hard to remove but it is right hand thread. You can remove the two 18mm bolts from the bottom of the strut and swing the whole wheel bearing assembly out just barely far enough to remove the axle without removing the lower ball joint. The axle is splined in the wheel bearing assembly and you can knock it out with a block of hard wood and a hammer. Reach back along the axle with a long extension and remove the two nuts holding the axle carrier bearing. Be careful not to let the axle fall down and damage the axle seal in the transmission. The axle should slide easily out of the transmission and only a tiny bit of fluid will leak out. Hope this helps. Good luck.
What else can I help you with?
Where is the fuel cut off switch on a Mazda tribute?
passenger front right side panel remove panel and the switch should be there
Where is the coolant drain plug on a Mazda Tribute?
Drain plug for the radiator for Mazda Tribute 2001 is located on the right side bottom of the radiator. You'll need to remove the right side mud guard to be able to access it.
What size Allen wrench to remove front brakes 2006 Mazda tribute?
To remove the front brakes on a 2006 Mazda Tribute, you typically need a 7mm Allen wrench (also known as a hex key) to remove the caliper bolts. It's a good idea to double-check the specific model and any service manuals for exact specifications, as variations might exist. Always ensure you have the right tools and follow safety procedures when working on your vehicle.
Remove door handle Mazda tribute?
Just try opening your door to get out and it will probably pop right off into your hand! That's what happened to me this morning. 2001 Mazda Tribute LX V6 piece of JUNK!
What is the number of each cylinder of a 2003 Mazda Tribute 3.0 engine?
Looking from the front of the 2003 Tribute at the engine, the cylinders at the front from left to right are 4-5-6. On the firewall side of the engine from left to right, the cylinders are 1-2-3.
How do you remove the motor mount of a 1996 Mazda 626?
which one right,left, front, rear
Where is the OBD II port on a 2002 Mazda Tribute?
The 2002 Mazda Tribute OBD 2 port is on rear edge of dash; right of hood release
Where is the oil filter in a Mazda tribute?
On the 2002 V6 it is near the front of the vehicle closer to the passenger side. Look to the right and behind the screw where you drain the oil and up into the crevasse.
Where is the horn in a 1996 Mazda Protege?
Just behind the right corner of the front bumper. You have to remove the black cover under the car to see it. Mazda hide it pretty well.
Where is the obd2 port located on 2001 Mazda tribute?
Just to the right of the hood release on backside of plastic covering
Where is the horn on a 98 Mazda Protege?
Well I had a 1995 Protege but I think is on the same place. It's beehint the right corner of the front cover. You have to remove the black cover under the car to see it. Mazda hide pretty well.
Where is the idle speed control actuator on a 2002 Mazda tribute?
I have a Mazda 2001 Tribute and I just replaced the Idle Air Control Valve (IAC). I searched for Idle Speed Control actuator and there does not appear to be one. The IAC is the silver module right on top of the manifold.
