0
What else can I help you with?
How do you remove the instrument cluster from a Mitsubishi Pajero?
I want re adjust its Mileage. How should I reach it mother bord ( Mitsubishi pajero) 2008
How do you remove a Mitsubishi Colt instrument cluster apart?
by putting them on water and one will eventually disolve
How do you get to the check engine light bulb?
You will have to remove and disassemble the cluster.
How do you replace a check engine light bulb?
You will have to remove and disassemble the cluster
How do you take apart the dashboard on a 1999 Mitsubishi galant?
If youre referring to the dashboard cluster, theres two screws in the top of the cowl housing on top, remove the bezel and remove the 4 screws holding in the instrument cluster.
How do you remove the gauge cluster trim on 1993 Mitsubishi Mighty Max?
Remove the upper corner screws first, and then the lower bottom screws second with a Phillips screwdriver. The lower bottom screws are hidden underneath the two square plastic tabs (caps)...you just need to pry them off with a flathead screwdriver, and then you'll have access to the two screws that's holding the instrument cluster lens. I found out myself by trial and error, nobody told me. This is how you reset the red "maint req'd" light that comes on after a preset mileage to remind you to service your Mitsubishi Mighty Max pickup truck. I own a 1991 Mighty Max myself and I perform all routine maintenance on it....I hope this pointer helps.
How do you reset the maint required light on a 90 Mitsubishi mighty max truck with 96K miles?
There is a reset button on the back of the light. Not easy to get to. You have to remove the inst. cluster. Taking the speedo cable is the hardest, but if you can reach it from the back, pinch the lever on the top of the connector and it will come off.
How do you remove a Mitsubishi eclipse transmission?
usaully by unbolting it from the engine and dropping it down, what year and what engine?
How do you change fan belt on 1995 Mitsubishi mighty max?
To change the fan belt on a 1995 Mitsubishi Mighty Max, first, ensure the engine is off and cool. Locate the tensioner pulley and loosen its bolt to relieve tension on the belt. Remove the old belt from the pulleys and install the new belt, ensuring it’s properly seated on all pulleys. Finally, re-tighten the tensioner and check the belt alignment before starting the engine.
Do you have to remove the crankshaft pulley to replace the balancer pulley belt on a 89 Mitsubishi mighty max 2.0-4-cylinder?
yes
Where is the fuel filter located on a 1988 Mitsubishi Mighty Max?
In front of the fuel tank. You will likely have to remove the rear driver side wheel to get to it.
How do you replace the bulb for the check engine light for a 1996 Audi?
To remove the cluster to get to the bulb, lower your steering wheel and remove the trim piece. Take out two screws and pull out the instrument cluster.
