answersLogoWhite

0

http://importnut.net/header.htm

User Avatar

Wiki User

17y ago

What else can I help you with?

Related Questions

Will a 1990 Honda Prelude hood fit on a 1994 Honda Prelude?

No, the third and fourth generation are a different Chassis.


What octane would a 1994 Honda Prelude use?

The 1994 Honda Prelude is best run with 91 octane fuel or higher. The vehicle is designed for use with high octane fuel.


Is a 1994 Honda Prelude s have a vtec engine?

A 1994 Honda Prelude S would not have a VTEC engine in it (assuming it has the original engine in it). It should have the F22A1 in it which is SOHC and Non-VTEC.


Why is the d4 light blinking on a 1994 Honda prelude?

Transmission error


How do remove the door panels on a 1994 Honda Prelude?

Using the correct sized screw driver, remove the screws and remove the clips that are in the door panel. Pull the panel away from the frame slowly, remove any wire connectors and then remove the panel from the frame.


Where is the thermostst on a 1994 Honda Prelude?

Just follow the lower water hose to where it meets the engine on the top and its that.. remove hose and three bolts and that's it.. drain the radiator first


Why is the oil light blinking red on a 1994 Honda Prelude?

You probably need to get your oil changed?


What is the 1994 Honda Prelude Si manual transmission capacity?

Approx 2 US qts.


Where is the diagnostic port on 1994 Honda Prelude?

Should be under dash or on side of the center console.


1994 Honda Accord ex remove rear rotor?

1994 Honda accord ex remove rear rotor


How do you remove air condition belt on 1994 Honda Accord?

How do you remove an air condition belt on a 1994 Honda Accord EX?


How do you remove interior dash board on my 1994 Honda Prelude?

To remove the interior dashboard of a 1994 Honda Prelude, start by disconnecting the negative battery terminal for safety. Next, remove any screws and clips securing the dashboard; typically, these are located around the instrument cluster and along the edges. Carefully pry off any trim pieces and disconnect any electrical connectors, such as those for the airbag or instrument panel. Once all fasteners and connections are detached, gently lift the dashboard away from the frame.