0
The arm is held on by a c-clip on the steel post that serves as the hinge and mounting point to the side of the seat. Simply stated, you pop that clip off and pull the armrest out, then slide the new one in and replace the clip. This sounds much easier than it is. In order to get to the c-clip you have to partially remove the seat cover. Reach up under the back of the seat and disconnect the plastic clip that holds the seat cover together at the bottom. Then you have to peel back the cover (mine's leather - a real challenge) until you can jam your hand up far enough to find the c-clip. Don't be afraid to really yank on the leather or fabric...it's tough. An upholsterer could probably do this in 15 minutes. It took me an hour and I was hot and tired when it was done. Good luck!
What else can I help you with?
How do you remove the door lock trim panel on 1999 suburban?
remove the inner door panel, you can access the bolts from the inside of the door.
Where is a fuel sending unit located on a 1999 Chevy suburban?
It is inside of the fuel tank. You will have to remove the tank to service it.
How do you remove front rotors from 1999 Chevrolet suburban?
Remove the tire and wheel from your 1999 Chevrolet Suburban. Remove the brake pads and break assembly. Tap on the rotor with a hammer or mallet. When the rotor is loose it will slide off.
How do you remove the window on a 1999 Chevy Suburban barn door?
with a brick
How to Replace window motor in a 1999 suburban?
How to remove the window motor from the regulator
How is the folddown armrest removed in a 99 ranger?
To remove the fold-down armrest in a 1999 Ford Ranger, first, locate the screws or bolts securing it to the seat. Use a screwdriver or socket wrench to remove these fasteners. Once the fasteners are removed, gently pull the armrest away from the seat, ensuring any clips or tabs are disengaged. If the armrest is attached to a seat cover, you may need to carefully detach the cover as well.
How do you remove fuel pump in 1999 suburban?
Located in fuel tank Probably have to be removed
How long does it take to remove a Chevy 350 motor from a 1999 suburban?
About 3 hrs. To take it out.
Do you have to drop engine to change flywheel in 1999 suburban?
NO. It would be easier to just remove the transmission.
In order to remove the intake manifold on a 1999 Chevrolet Suburban 5.7 do you have to loosen or remove the distributor?
Yes you do. The distributor must be removed.
How do you change a fuel pump on a 1999 Suburban 4WD?
Located in the fuel tank - may have to remove for access
How do you check the flex plate on a 1999 suburban with a 350?
Should be able to remove the inspection cover and look at it.
