answersLogoWhite

0

What else can I help you with?

Related Questions

Will a 2000 timing belt cover 4 Mitsubishi eclipse fit a 93 Mitsubishi eclipse?

No, it will not.


How do you install a Mitsubishi eclipse driver mirror?

To install the Mitsubishi Eclipse driver mirror, you will need to remove the interior door panel on the driver's side. Then, remove the cover for the mirror screws. Remove the screws and wiring and remove the old mirror. Replace the wiring and screws as you add the new mirror to the car. Then place the cover and the door panel back on the vehicle.


Where do you iI add oil to 2001 Mitsubishi eclipse?

There is an oil cap on the top of the valve cover. Remove the cap, add some oil.


How do you replace the timing belt on a 1992 Mitsubishi eclipse 4 cylinder dohc manual?

Remove the timing belt cover. There should be a pully that will ratched in and out to tighten and loosen the belt.


Where is the water pump on a 2001 Mitsubishi eclipse GT?

You need to remove the timing belt cover in order to gain access to it. If you want to replace it, timing belt has to be removed too.


How do you remove the headlamps on a 1999 Mitsubishi Eclipse 2L Non-Turbo?

In order to remove the whole assembly, you have to remove the front bumper cover which will expose a bolt on the bottom of the assembly which has to be removed...along with the bolt on top of the radiator support beam on each headlight!


What are the steps to remove a 2003 Mitsubishi Eclipse dash board?

Remove the plastic cover going around the board. It sits on clips. After you will see 4 screws holding the board. Remove them too. Pull out carefully the board, disconnect 3 wire harnesses.


Where is the crankshaft position sensor located on a 1998 Mitsubishi Eclipse?

Crank position sensor is located next to the crankshaft. In order to replace it you might have to remove the timing belt. In the most models you just can remove remove the timing belt cover and replace the sensor.


1999 eclipse Mitsubishi flywheel cover located?

between the tranny and engine block good luck


How do you disarm a 97 Mitsubishi eclipse gs factory alarm?

You can disarm your 1997 Mitsubishi Eclipse factory alarm system by removing the alarm fuse. The location of the alarm fuse can be found on the inside cover of the fuse box.


Where is locate the starter on Mitsubishi eclipse 1991?

On a 1991 Mitsubishi Eclipse, the starter is located on the lower side of the engine, near the transmission. Specifically, it can be found on the right side of the engine block, close to the rear. To access it, you may need to lift the vehicle and remove any obstacles, such as the engine cover or heat shield, for better visibility and access.


Where is the number 1 cyl on a 95 eclipse?

the number one cylinder on a Mitsubishi eclipse 4g63 will be closest to you cam gears. on the far right of the valve cover