The 1999 Suzuki Grand Vitara OBD 2 port is on lower edge dash, right of steering column; near center console
A side panel near your feet on the driver and passenger side. You have to remove the lower sill cover on the entry way to the door before you can remove the kick panel. The kick panel may contain electrical parts and wiring bundles.
The 2002 Suzuki Vitara OBD 2 port is on lower edge of dash, right of steering column; near center console
On a 2000 Suzuki Grand Vitara, the crankshaft position sensor is typically located near the crankshaft, often found on the engine block or transmission bell housing. Specifically, it is usually positioned on the lower part of the engine, near the oil pan or the front of the engine, depending on the engine configuration. To access it, you may need to remove some components or covers. Always refer to the vehicle's service manual for exact location and removal instructions.
On a 2002 Suzuki Grand Vitara, grease fittings are typically located on the front suspension components, such as the lower control arms and ball joints. You may also find them on the tie rod ends and the driveshaft U-joints. It's important to refer to the vehicle's service manual for specific locations and maintenance recommendations. If you're unsure, consulting a professional mechanic can help ensure proper lubrication.
The blower motor on a 2004 Suzuki Vitara V6 is located inside the passenger side footwell area, typically behind the glove compartment. To access it, you'll need to remove the lower dash panel and possibly the glove compartment itself. The blower motor is mounted on the HVAC housing and is connected by wiring and a few screws for easy removal.
On a 1999 Suzuki Grand Vitara, grease nipples are typically found on the suspension components, such as the upper and lower ball joints, tie rod ends, and possibly on the sway bar links. They may also be located on the driveshaft U-joints. To locate them, inspect these areas for small fittings that allow for the addition of grease. Always consult the vehicle's service manual for precise locations and maintenance recommendations.
usually at the bottom or rear of the radiator - or remove the lower radiator hose
* If the bike is fully faired, remove lower fairing cowel * Look behind the lower left hand downtube which cradles the engine
To replace the rear brake drums on a 2000 Suzuki Vitara, start by safely lifting the vehicle and removing the rear wheels. Next, remove the retaining screws or clips holding the brake drum in place, then gently tap the drum with a hammer if it's stuck. Slide the old drum off, and replace it with the new one, ensuring it fits snugly. Finally, reattach the retaining screws, reinstall the wheels, and lower the vehicle.
The Suzuki Vitara typically has two ball joints on each front side, one for the upper control arm and one for the lower control arm. This means there are a total of four ball joints in the front suspension system. However, the exact configuration may vary depending on the specific model year and suspension design. Always consult the vehicle's service manual for detailed specifications.
it is under the drivers side lower dash its a DL 16 plugOn all OBD-II equipped vehicles, the diagnostic connector should be visible when you look horizontally at the lower edge of the dashboard on the driver's side. You should not have to look up, into the backside of the dashboard.