0
I have a 94 Camry and it has the same body as the 96 model
There are approximately 22 nuts, bolts and screws to remove in order to remove the rear bumper. The locations are as follows. You will need a Phillips screw driver and a rachet with a 2 inch extension and 10mm/12mm sockets.
External1) One bolt Under each of the rear wheel arches.2) 2 Screws on each side underneath the bumper on the two sides (just behind the wheels)3) 1 Clip on each side underneath the bumper at the 2 edges. (I had to break these clips as I could not remove them)4) 1 screw type clip on the top side of the bumper, just below the tail light. (the screw needs to be turned and pryed up before the clip can be removed)
InternalThe back and side boot linings must be removed in order to have access to the nuts and bolts.1) 3 bolts on each side of the body (just behind the wheel arch) located at the top level of the body.2) Several nuts (approximately 8 nos. if I remember right) at the back panel of the body at the top level of the bumper. Theses can be identified as tapered edge of the bolt sticks out about 5mm beyond the edge of the nut).
Once all these are removed, remember to remove the licence plate light wire from the inside of the boot. My bumper came off when I pulled the it up several times, holding it from the bottom edge.
Hope this helped. Good luck.
Lalith.
What else can I help you with?
How do you remove a 2000 Toyota Camry rear bumper?
To remove the rear bumper from a 2000 Toyota Camry, start by opening the trunk and removing any interior panels or screws that secure the bumper. Next, locate and remove the bolts or clips underneath the bumper, typically found near the rear wheel wells. Once all fasteners are removed, gently pull the bumper away from the vehicle, taking care not to damage any wiring or connectors. Finally, disconnect any electrical connections if applicable, and set the bumper aside.
How do you remove the rear brake drums from a 1996 Toyota Camry?
Remove the wheels, pry the drums off.
How do you remove the passat rear bumper?
how to remove 2013 passat rear bumper
How do you remove rear bumper from 1999 Ford Taurus?
Remove rear bumper on 99 ford tarrus
How do you remove rear bumper jaguar x-type?
how do you remove and replace rear bumper on an xtype jag
How much to repair 2009 Toyota Camry rear bumper?
30
What do you need to replace the rear bumper on 1988 Toyota Camry?
There should be 2 access plugs on each side in the trunk. Remove the bolts and slide the bumper out. Maybe a foot in from each side.
How do you remove and install a 1998 Toyota Camry rear bumper cover?
Hi, I was looking for instructions as to "How to replace 1998 Toyota Camry rear bumper cover" and you got your question. If you have already replaced then please let me know otherwise I'm going to replace the part this weekened and I will let you know. Take care, Sam
How do you remove the rear bumper on a 2004 Nissan Sentra?
To remove the rear bumper on the 2005 Nissan Sentra, you will first need to remove the rear bumper cover by using a flat tool to pry the pins. Then, access the bolts holding the bumper to the frame of the vehicle and remove the nuts. The bumper will then lift off.
How do you remove a vw passat 55 rear bumper?
Removing the Rear Bumper of a Passat...
Where is the rear parking sensor speaker in a Toyota Camry 2009?
Usually such sensors are located in the rear bumper.
How do you replace a rear bumper cover on a 2000 Toyota Camry?
To replace the rear bumper cover on a 2000 Toyota Camry, first, remove any screws, clips, or fasteners securing the bumper to the vehicle, which are typically located in the wheel wells and under the rear of the car. Next, gently pull the bumper away from the body, disconnect any electrical connections for lights if applicable, and then remove the old bumper cover. Align the new bumper cover with the mounting points, reconnect any electrical components, and secure it with the screws and clips you removed earlier. Finally, ensure everything is tightly fastened and check for proper fit.
