0
you have to take off all the trim starting from the piece in the boot against the rear of the car. For each piece, take out all the screws and then pull (there will be some force required because there are also plastic clips holding these in that pull out). If the piece isn't budging, you're probably missing a screw.
Once the trim is gone, I think you have to drill out the places where the speaker is held into the frame. Either that or they screw out...
What else can I help you with?
What are the stereo wiring schematics for a 2002 Toyota Celica GT-S?
2004 Toyota celica stereo diagram
What is the bolt pattern for a 2002 Toyota Celica?
5x100
How do you remove rear speaker covers and speakers 2002 Toyota Camry SE?
use a flat screw driver.
How do you remove PCV valve on a 2002 Toyota Celica?
The pcv valve should be located on top of the valve cover. It plugs in, and should pull out with some gentle coaxing.
How many pounds does a 2002 Toyota Celica weigh?
The 2002 Toyota Celica has a curb weight of approximately 2,800 pounds, depending on the specific model and equipment. This weight can vary slightly based on factors such as trim level and optional features.
How do you remove the evaporator in 2002 Toyota corolla?
How i remove eveporator unit from toyota corolla 2002
How do you remove the shift knob on a 2002 Celica GT?
twist it HARD
What is a good aftermarket spark plug for a 2002 Toyota Celica?
Pulstar Iridium Pulse Plug
Where can you find a repair manual for a 2002 Toyota Celica?
Try e-Bay. I've seen them in there.
Speaker size in a 2002 Toyota Corolla?
they are 6x9 speakers
How many quarts of oil it does it take to refill a Toyota Celica?
it takes 5 quarts. the same amount for any small engine car. be sure to remove and drain the filter during this process and to install a new one. well that's a load of crap^^My 2002 Toyota Celica GT takes only 3.7 USQuarts.
How do you remove center console in 2002 Toyota Celica gts?
To remove the center console in a 2002 Toyota Celica GTS, start by disconnecting the negative battery terminal to avoid any electrical issues. Next, remove any screws or bolts holding the console in place, typically found under the armrest and near the gear shifter. Carefully pry off any trim pieces and disconnect any electrical connectors before lifting the console out of the vehicle. Take your time to avoid damaging clips or surrounding components.
