There is a slot below the tailgate and above the bumper. The same crank you use on jack fits through there and goes above spare tire onto a chain gearbox drive. Should be able to pull tire down enough to see chain gearbox drive and line up to crank. spray chain gearbox drive liberally with lube if it is as rusty as mine was and work back and forth to free up.
195 deg.
.012 int.-.012ex.
Various parts and accessories of 1987 Mazda B2000 have been put on sale on various websites like eBay. The various parts and accessories range between $10 and $200.
Yes, a Mazda B2000 is most definitely a 4-cylinder with a 2.0L engine. However, technically Mazda didn't produce the B2000 as a 1988 model. It was made in 1986-1987. Then in 1989 Mazda made the B2200 Pickup, which is a 2.2L 4 cylinder.
14" x 5.5", 6 Lug
To remove the instrument panel on a 1987 Mazda B2000, start by disconnecting the negative battery cable to ensure safety. Remove any screws securing the trim bezel around the instrument panel, then carefully pry it off using a trim tool. Next, unscrew the instrument panel itself and disconnect the wiring harnesses at the back. Once everything is detached, you can lift out the instrument panel for replacement or repair.
The most likely cause is a blown head gasket.
The power steering reservoir for the 1987 Mazda B2000 truck is typically located near the front of the engine compartment, mounted on or near the driver's side. It is a small, translucent tank with a cap that is usually labeled for easy identification. To check the fluid level, simply remove the cap and inspect the markings on the side of the reservoir. Make sure to add the appropriate power steering fluid if needed.
It is below the HIGH pressure line. Usually smaller than the other.
it will fit the b2200, b2000,b2600. I think 1987 to 1993.
Gross Vehicle Weight= 2450 kg or 5401 lbs Curb Weight= 4400 lbs
Very carefully.