0
Open your trunk and pull back on the grey stuff on the right side (passengers side) and look for the cord thingy that's the largest one, it will be locked so turn it and pull out to get to the light bulb. Remove the taillight and go to a local auto supplies shop and show a work your old light and then you just screw the new light in and plug it all back in and close the grey cover. Hope this helps :)
What else can I help you with?
How do you replace the taillight bulb on a Nissan Armada?
Remove the taillight assembly to gain access to the bulbs
How do you replace taillight on Toyota T-100?
How do you remove taillight cover on a T-100 toyota Truck
How do you remove the taillight cover on a 2004 Jeep Liberty?
To remove the taillight cover on a 2004 Jeep Liberty, start by opening the rear hatch and locating the screws securing the taillight assembly. Use a screwdriver to remove these screws, then gently pull the taillight assembly away from the vehicle. Disconnect the wiring harness by pressing the release tab and pulling it out. Once detached, you can access or replace the taillight cover as needed.
How do you remove taillight from 2013 mini countryman?
To remove the taillight from a 2013 Mini Countryman, first, open the rear hatch and locate the two screws securing the taillight assembly. Remove these screws using a Torx or Phillips screwdriver. Gently pull the taillight assembly away from the body of the car to detach it, being careful to disconnect the wiring harness at the back. After removing the taillight, you can replace or service it as needed.
How do you change the taillight in a 2003 jeep grand Cherokee Laredo?
Open the rear hatch. you will see 2 screws on the side of the taillight. Remove them and pull the taillight out.
How do you change a taillight on a 1997 ford explorer?
Open the liftgate Remove the 2 screws at the top of the taillight assembly Carefully " work " the taillight straight back towards you . There are plastic pins shaped >>>>>>>>>>>> that hold the taillight assembly in place The bulb sockets are a simple turn to remove / install
How do remove the taillight from a 2003 Ford Escape?
To remove the taillight from a 2003 Ford Escape, start by opening the rear hatch and locating the two screws or bolts securing the taillight assembly. Remove these screws using a socket or screwdriver. Once the screws are removed, gently pull the taillight assembly straight out from the vehicle, disconnecting any wiring harnesses attached. Finally, set aside the taillight for replacement or repair.
How do you remove taillight cover on 2002 Ford Focus?
From the inside.
How do you change a taillight bulb in 2006 Mustang?
* Remove the rear inside trunk finishing panel to access the taillight housing mounting nuts * Free the grommet for the taillight electrical harness and the three taillight housing nuts then pull off the taillight housing * Rotate the bulb socket counterclockwise and pull it out of the taillight housing * To remove the bulb from the socket pull it straight out.To install a new bulb in the socket push it straight into the socket until it stops
How do I Replace tail light 2006 mustang?
Taillight bulb replacment/Taillight housing replacement * Remove the rear inside trunk finishing panel to access the taillight housing mounting nuts * Free the grommet for the taillight electrical harness and the three taillight housing nuts then pull off the taillight housing * Rotate the bulb socket counterclockwise and pull it out of the taillight housing * To remove the bulb from the socket pull it straight out.To install a new bulb in the socket push it straight into the socket until it stops
How to Remove taillight assembly in VW touareg?
To remove the taillight assembly in a VW Touareg, first, open the rear hatch and locate the access panel inside the cargo area, usually on the side where the taillight is mounted. Remove the screws or clips holding the access panel in place, then disconnect the electrical connector from the taillight. Finally, unscrew the bolts securing the taillight assembly and gently pull it out from the body of the vehicle. Be careful not to damage any clips or wiring during the process.
How do you replace a taillight bulb on a 2006 ford mustang?
* Remove the rear inside trunk finishing panel to access the taillight housing mounting nuts * Free the grommet for the taillight electrical harness and the three taillight housing nuts then pull off the taillight housing * Rotate the bulb socket counterclockwise and pull it out of the taillight housing * To remove the bulb from the socket pull it straight out.To install a new bulb in the socket push it straight into the socket until it stops
