take off the wheel. unbolt the 2 lower strunt bolts, to swing the brake assembly out, pull that end of the axel out, then give the axel a good pull out and it should pop out of the transmission.
The starter on a 1991 Toyota Tercel is located in the front of the engine. It will be located on the left side.
The timing marks on a 1991 Toyota Tercel are on the crank pulley. They are located on the front of the pulley and under the cam.
Yes, drums on the rear, discs on the front.
To change the front brake pads on a 1989 Toyota Tercel, first, lift the vehicle and remove the front wheels. Then, remove the brake caliper by unscrewing the caliper bolts, and carefully slide the caliper off the rotor. Take out the old brake pads and replace them with new ones, ensuring they are properly seated. Finally, reattach the caliper, tighten the bolts, and reinstall the wheels before lowering the vehicle.
You have to remove the hole corner lamp so you can get to the bulb in the back, you just need a srew driver
There is a little wedge at the bottom, stick a nail fail there and pop it out. Then you just have to pull the cover down to reveal the speakers
To replace the front axles on a 1995 Toyota T-100, first, lift the vehicle and secure it on jack stands. Remove the front wheels, then detach the brake calipers and rotors for better access. Next, unbolt the axle nut and the lower control arm, allowing the axle to be pulled out from the hub. Finally, install the new axles by reversing the removal process, ensuring all components are properly torqued and secured.
The 2006 Toyota Sienna has two axles. It is a front-wheel-drive minivan, meaning it utilizes a front axle for power delivery and a rear axle for support. This setup is standard for most passenger minivans.
The ignition coil on a 1995 Toyota Tercel is located on the engine compartment, typically mounted on or near the engine block. It is usually situated on the passenger side, near the front of the engine, and connected to the distributor. To access it, you may need to remove any covering or components obstructing the view.
To replace the front wheel bearings on a 1994 Toyota Tercel, first, lift the vehicle and remove the front wheel. Next, disconnect the brake caliper and rotor, then remove the hub assembly by taking out the hub nut and any retaining bolts. Carefully press out the old wheel bearings from the hub and replace them with new ones, ensuring proper alignment and lubrication. Reassemble the hub, rotor, and caliper, and then reinstall the wheel before lowering the vehicle back to the ground.
On a 1993 Toyota Tercel, the horn is typically located near the front of the vehicle, behind the grille. It is usually mounted on or near the radiator support. To access it, you may need to remove the grille or other components depending on the specific setup of your vehicle. Always consult the owner's manual for precise information and guidance.
To replace the front struts on a 1995 Toyota Tercel, first, safely lift the vehicle and secure it on jack stands. Remove the front wheels, then detach the brake line and any necessary components from the strut assembly. Unbolt the strut from the steering knuckle and the top mount under the hood. Finally, install the new struts by reversing the removal process, ensuring all bolts are torqued to specification.