0
To remove the water pump from a 1985 MR2, start by disconnecting the negative battery terminal and draining the coolant. Then, remove the serpentine belt and any associated components obstructing access to the water pump, such as the timing cover and the alternator. Unbolt the water pump from the engine block, carefully prying it loose if necessary. Finally, clean the mating surfaces and install the new pump with a fresh gasket before reassembling everything in reverse order.
What else can I help you with?
Where is the fuel pump relay in the 1985 Toyota MR2?
In the 1985 Toyota MR2, the fuel pump relay is located in the fuse box, which is situated on the driver's side of the dashboard, near the door. To access it, you'll need to remove the cover of the fuse box. The relay can be identified by its labeling or by consulting the fuse box diagram found on the inside of the cover.
How do you remove the fuel pump on a 1984 mr2?
remove fuel tank located between the two seats under car and remove fuel pump.
How do you replace a water pump on a 1987 MR2?
To replace the water pump on a 1987 MR2, first disconnect the battery and drain the coolant. Remove the timing belt cover, then take off the timing belt by loosening the tensioner. Next, unbolt the water pump from the engine block, clean the mounting surface, and install the new pump with a new gasket. Reassemble by reinstalling the timing belt and cover, refilling the coolant, and reconnecting the battery.
Do you take off the timing cover on a mr2 when replacing the water pump?
yes you do i had to take mine off when i replaced my water pump
How do you replace the water pump on a 1991 Toyota MR2?
changing the water pump is quite involved. I recommend a manual. The BGB is expensive, but is well worth it.
How do you replace the fuel pump and fuel filter on a 1985 Toyota MR2 and where is the fuel pump?
To replace the fuel pump and fuel filter on a 1985 Toyota MR2, first, safely relieve the fuel system pressure by removing the fuel pump relay and starting the engine until it stalls. The fuel pump is located inside the fuel tank, so you'll need to remove the tank by disconnecting the fuel lines, electrical connectors, and mounting bolts. After removing the tank, access the fuel pump by taking off the access plate on top of the tank, replace the pump and filter, and reassemble everything in reverse order. Be sure to check for leaks after reinstallation.
How do you change the clutch cable on an 1985 mr2 na?
You have a hydraulic clutch in your mr2, no cable.
Where is fuel pump on 1986 mr2 toyato?
In the 1986 Toyota MR2, the fuel pump is located inside the fuel tank. To access it, you'll need to remove the fuel tank, as it is not an external pump. It's important to disconnect the battery and relieve fuel pressure before attempting any repairs for safety reasons.
How to remove the fuel pump on 1988super charge mr2 Toyota?
To remove the fuel pump from a 1988 Toyota MR2 with a supercharged engine, first, disconnect the negative battery terminal to prevent any electrical issues. Then, access the fuel pump by removing the rear trunk carpet and the fuel pump cover. Disconnect the electrical connector and fuel lines, and then unbolt the pump from its mounting. Carefully lift the pump out, ensuring that any O-rings or seals are also removed for replacement during reinstallation.
Where at is the fuel pump on a 1986 mr2 what position in the tank?
the fuel pump is in the fuel tank
Where is the starter located on a 1985 Toyota MR2?
On a 1985 Toyota MR2, the starter is located on the driver's side of the engine bay, near the rear of the car. It is mounted to the engine block and can be accessed from underneath the vehicle or from the top with some effort. To reach it, you may need to remove the air intake or other components for better access.
What is the spark plug gap on 1985 MR2-1600?
.043
