It is under the carpet on the passenger front seat on US models. You remove any clips holding the front of the carpet in place and peel it back. From there on it is unscrewing things until you get it out. Plug and play, that is there are no adjustments or settings, you just put the new one in and it sets itself up.
its three screws. and threw plugs
how do you replace the drivers side drive shaft and cv joint?
where is the ECM located on my 2000 Jimmy? where is the ECM located on my 2000 Jimmy?
The Engine Control Module (ECM) for a 1996 Subaru Legacy Outback is typically located in the passenger compartment, specifically under the dashboard, near the driver's side. You may need to remove some trim panels to access it. It is usually mounted on the firewall or the side of the center console. Always ensure to disconnect the battery before attempting to access or replace the ECM.
replace the ecm
The short answer is yes.
Depends on where you go and where you live.
you can't fix an ecm, you have to replace it.
Where is the ecm located in a 2000 Chevy Malibu
2000 Outback Bowl - 2000 TV was released on: USA: 1 January 2000
The ECM is mounted on the center of the firewall behind the dash. It requires removal of most of the dash panel to replace. 'Ya think maybe they didn't want anybody to mess with it?
Most are just screwed to firewall with a few plugs so its easy. It must be an ecm for the same engine, yr, fuel, etc and will relearn fuel curves etc.