answersLogoWhite

0

you have to find out which o2 sensor you need first. when you find out which sensor by getting the code with an obdII scanner. it will say o2 sensor bank 1 sensor 1 or o2 sensor bank 1 sensor 2 (#1 is in the exhaust pipe closest to the header or exhaust manifold assy, #2 is also in the exhaust pipe but is after the catalytic converter) buy the correct part based on the code. replacing it once found is simple. remove the 2 12mm nuts that hold it in, slide it out of the pipe, remove the old gasket, and unplug the sensor from the harness. then replace the gasket, put the new sensor in where the old one came out, install and tighten the nuts, then plug it in. clear the codes with the scantool or by removing the negative battery terminal for a minute or so then replacing it, and you're all set

User Avatar

Wiki User

19y ago

What else can I help you with?

Related Questions

Why cant i get hot air from vents on Toyota Previa 96?

where is the heater core in a 1992 Toyota previa


How do you change blower resister on 96 Toyota Previa?

shaking the blower resister


What size is the gas tank on a Toyota Previa?

I own and drive a 96 Previa and was amazed to find out the capacity is 19.8 gallons US . (according to Alldata online)


Where is o2 sensor on previa 96?

On a 1996 Toyota Previa, the oxygen (O2) sensor is typically located on the exhaust manifold or just downstream in the exhaust pipe. There are usually two O2 sensors: one before the catalytic converter (upstream) and another after it (downstream). You may need to lift the vehicle for better access, as the sensor is positioned underneath. Always consult the vehicle’s service manual for specific details and diagrams.


How do you replace map sensor on 96 Nissan Maxima 3.0?

can you tell me were the map sensor


Is O2 sensor on 96 cavalier easy to replace?

Yes


What size socket do you use to replace o2 sensor on 96 quest?

22mm


Where is oxygen sensor for 96 Toyota t1oo located?

There are two of them, one on either side of the catalytic converter in the exhaust system.


How do you replace the distributor on a 96 Chrysler cirrus 2.5 liter?

Are you sure you need to replace it? Is it a no-spark condition? Might want to check the Crankshaft Position Sensor first.


When should i replace timing chain on 96 Previa?

The timing chain will normally last the life of the engine and is replaced when the engine is rebuilt.


Is the crank sensor location on a 97 breeze different than the 96 becasuse it doesn't seem to be there to replace?

The sensor is located behind the front passenger wheel behind the oil filter


Where is a knock sensor located at on a 96 Pontiac Bonneville?

where is a knock sensor located on a 96 Pontiac Bonneville