Take out the transfer case and the transmission. It's not too hard, just keep track of the wiring connections, etc.
in the tank
The wheel bolt diameter for a 2007 Toyota Tacoma is 12mm x 1.50.
Try Auto Zone.com
You take it to AAMCO
No, you should not grease the throw-out bearing on a 1999 Toyota Tacoma 4WD pickup. Throw-out bearings are typically sealed and pre-lubricated, and adding grease can interfere with their operation and lead to premature failure. If the bearing is making noise or showing signs of wear, it's best to replace it rather than attempt to grease it.
Toyota tacoma come in 2wd RWD not FWD 4 cylinder... 4WD 6 cyl 2wd RWD around 20mpg
if it is a 4wd you need to remove the engine from the vehicle
will a 1997 2 wheel drive tacoma fender fit a 4 wheel drive tacoma truck truck
You should remove the positive cable from your 1996 Toyota battery. Remove the cables from the front of the starter. Remove the starter retaining bolts. Reverse the process to install the new starter.
The most expensive part of a clutch job in your Toyota will be (as it always is) the labor; 5 to 6 hundred dollars. The clutch assembly is about 450.00$. There may be incidentals added to this, so bank on about 1,000.00$. I have a 1991 4runner with 312 thousand kiometres on the original clutch. Try to find that on any other model, North American or other.
The PreRunner is not 4WD and is only a RWD truck. Other than not having the 4WD transfer case and front differential it is identical to the 4WD truck. All other parts are the same.
on some toyotas if you pull the EFI fuse found under the hood, keep it out for 1 minute then replace. it will reset egn light