You need to disconnect the battery, after that remove plastic and metal cover underneath the steering wheel. After that you get access to the key cylinder, disconnect the harness, remove nuts. Install a new key cylinder, tighten the nuts, connect the harness to. Install the plastic and metal cover. Connect the battery.
You might want to try the cylinder before installing plastic cover.
1997 Toyota Camry ignition switch removal
To replace the ignition cylinder on a 1989 Toyota Camry, start by disconnecting the negative battery cable to ensure safety. Remove the steering column covers by unscrewing the screws, then locate the ignition cylinder. Insert the key and turn it to the "Run" position while pressing the release tab on the cylinder to pull it out. Finally, install the new ignition cylinder by reversing the steps, ensuring it locks in place securely.
Where is the thermostat located and how do you replace it on 1992 toyota camry 4 cylinder ingine
Where is the horn relay located on a 4 cylinder Toyota camry?
No, you cannot.
No. The coil is the piece at the other end of the wire that comes out of the center of the distributor cap.
May not be your car, but proceedure same http://forums.travel.com/toyota-camry-forum/617282-1993-toyota-camry-4-cylinder-ignition-coil.html Hope it helps
2 on the 4 cylinder engine or 6 on the 6 cylinder engine.
No, it's easy.
4is it 4 or 6 cylinder ? It is a 4 cylinder
The 2.4 liter four cylinder engine in a 2009 Toyota Camry has a timing CHAIN
Toyota recommends every 90K.