answersLogoWhite

0

First, remove the engine air intake tube from the engine,(clamp on the tube on the engine throttle body). Remove the clamp on the other end of the tube going to the airbox. Remove the intake tube. Center, top of transmission will be a sensor with 2 wires,(plug). Depress sides of plug and remove. A 22mm socket with an extension will remove the sensor/clear the female plug portion of the switch if it is a DEEP WELL SOCKET ONLY!

Reinstall to factory torque specs. Use care if not using a torque wrench as the transmission housing is aluminum and could crack if sensor is over tightened .

Re- install intake tube ensuring no leaks.

Test. Go get your sticker-smirk-.

User Avatar

Wiki User

13y ago

What else can I help you with?

Related Questions

How do you change turn signal switch Hyundai Tiburon?

To change the turn signal switch on a Hyundai Tiburon, first disconnect the negative battery terminal to ensure safety. Remove the steering wheel by taking out the steering column cover and any necessary screws or bolts. Then, detach the old turn signal switch from its connector and replace it with the new one, reassembling everything in the reverse order. Finally, reconnect the battery and test the new switch to ensure it works properly.


Where is the reverse switch on a 2005 Hyundai tiburon?

The reverse switch on a 2005 Hyundai Tiburon is typically located on the transmission itself. Specifically, it can be found on the side of the transmission housing, near where the shift linkage connects. To access it, you may need to lift the vehicle and remove any protective covers or components obstructing the view. Always ensure the vehicle is securely supported before attempting any maintenance.


How do you replace the ignition switch on a Hyundai tiburon diagram?

To replace the ignition switch on a Hyundai Tiburon, first disconnect the negative battery terminal to ensure safety. Remove the steering column cover by unscrewing any screws or clips holding it in place. Disconnect the wiring harness from the old ignition switch, then unscrew and remove the switch itself. Install the new ignition switch by reversing these steps, ensuring all connections are secure before reattaching the battery.


Where is the overdrive switch on a 2001 Hyundai tiburon?

It is located on the gear shift handle.


Where is the reverse light switch on a 2004 tiburon?

On a 2004 Hyundai Tiburon, the reverse light switch is located on the transmission. Specifically, it is typically found near the shift linkage or on the side of the transmission case. To access it, you may need to lift the vehicle and remove any necessary undercarriage covers. Always consult the vehicle's service manual for precise location and instructions.


How do you replace a 1997 Hyundai Tiburon ignition switch?

Drop the steering wheel, at the back of the ignition there are wires with a screw in the middle edge. Remove the screw, unplug the connector and it comes right out.


Where is the fuel pump relay switch located on a 1999 Hyundai Tiburon Fx?

The fuel pumpis located in the fuel tank.


How do you check brake light switch on 2004 Hyundai tiburon?

To check the brake light switch on a 2004 Hyundai Tiburon, first, locate the switch, which is typically mounted on the brake pedal assembly. Disconnect the electrical connector from the switch and use a multimeter to test for continuity; the switch should show continuity when the brake pedal is pressed. If there's no continuity, the switch may be faulty and should be replaced. Additionally, inspect the switch for any signs of damage or misalignment.


Where is the brake light switch on a Hyundai tiburon 2003?

The brake light switch on a 2003 Hyundai Tiburon is typically located above the brake pedal, mounted on the brake pedal assembly. To access it, you may need to remove the under-dash cover on the driver's side. This switch is responsible for activating the brake lights when the pedal is pressed. If you're experiencing issues with your brake lights, checking this switch is a good starting point.


Where is the fuel reset on a 1998 Hyundai Tiburon?

The fuel reset switch, also known as the inertia switch, on a 1998 Hyundai Tiburon is typically located in the trunk area. You can find it on the driver's side, near the rear taillight assembly. If you need to reset it, simply press the button on the switch after a fuel-related incident, such as a collision or running out of gas. Always consult the vehicle's manual for specific details and locations.


Where is the on switch for the heated seats for a 2005 Hyundai tiburon?

In a 2005 Hyundai Tiburon, the on switch for the heated seats is typically located on the center console, near the gear shift. There are usually two buttons for each seat, one for low heat and one for high heat. Make sure the car is running for the heated seats to work, and check that the buttons light up when activated.


Where is the fog light switch on a 2001 Hyundai tiburon?

On a 2001 Hyundai Tiburon, the fog light switch is typically located on the left side of the steering column, integrated into the headlight control stalk. To activate the fog lights, you usually need to turn the headlight switch to the "on" position and then pull the stalk towards you or push it away, depending on the specific configuration. If the fog lights are not functioning, make sure to check the fuse and bulbs as well.