0
What else can I help you with?
How do you replace a water pump on an 1987 Honda accord lx?
The water pump is located in the timing belt area. If its leaking you will want to replace the belt also as coolant will shorten the life of the belt. Don't forget to check the crankshaft & camshaft oil seals and do them while you're in there.
How do you replace EGR on 1987 Mazda B2200 Truck?
This has been answered and do a seach and it will take you step by step and word it just as you placed your question about it!
How do I keep my 1987 Subaru GL from overheating?
is your car equipped with a coolant overflow bottle replace thermostat have radd removed flushed and rodded
When was I Will Be There - Dan Seals song - created?
I Will Be There - Dan Seals song - was created in 1987-01.
How do you replace fuel injectors for 1987 Nissan truck?
YOU HAVE TO UNBOLT THE FUEL RAIL, THEN UNBOLT THE FULE INJECTOR SECURING BOLTS( THERE ARE 8 OF THEM) THEN JUST REMOVE THE ENTIRE FUEL RAIL WITH INJECTORS ATTACHED. BE CAREFUL TO REPLACE ALL SEALS,
How do you replace valve guide seals 1987 Mazda B2000?
1. remove valve cover bolts. 2. use a screwdriver or small pry bar to remove valve cover 3.fill engine with gasoline. 4.carefully strike a match, and toss it into the engine. 5. locate your nearest used car dealership. 6. buy a Toyota.
Where is the coolant temp sensor on a 1987 Pontiac fiero gt?
where is the coolant temperature sensor locate
When was The Best - Dan Seals album - created?
The Best - Dan Seals album - was created on 1987-10-20.
How can you tell the difference between intake valve and exhuast valve on a 1987 Chevy 305 want to replace valve stem seals but intake and exhaust are different seals which one is which?
intake valves are the larger valves or if you count from from either end its number 2,3,6,&7 valve
How do you replace the radiator 1987 Jeep Comanche?
To replace the radiator in a 1987 Jeep Comanche, first, drain the coolant by opening the petcock at the bottom of the radiator. Disconnect the hoses, electrical connectors, and any mounting bolts securing the radiator in place. Remove the old radiator and install the new one, ensuring it aligns properly with the mounts. Reconnect the hoses and electrical connections, then refill the cooling system with new coolant and check for leaks.
How do you replace a water pump on a 1987 MR2?
To replace the water pump on a 1987 MR2, first disconnect the battery and drain the coolant. Remove the timing belt cover, then take off the timing belt by loosening the tensioner. Next, unbolt the water pump from the engine block, clean the mounting surface, and install the new pump with a new gasket. Reassemble by reinstalling the timing belt and cover, refilling the coolant, and reconnecting the battery.
How do you replace water pump on a 1987 Mazda B2200?
DRAIN AND REMOVE RADIATOR.SHROUD AND FAN REMOVE WATER PUMP,RE-INSTALL PUMP WITH SILICONE SEALENT..GOOD LUCK ..toro2
