answersLogoWhite

0

Locate and identify the master cylinder. Remove top and suction out brake fluid ( A turkey baster works well for this. Remove all steel brake lines, primary and secondary. Unhook wires for low level sensor, Unbolt and remove master cylinder. Install new or rebult one same way opposite order, Refill with DOT and Toyota approved brake fluid. Then VERY important: bleed all four corners until you have NO air and clean clear brake fluid, at least 3 times even if the first or second go~around seems to have no air. Please dispose of used brake fluid in a responsible manner. After 100 miles bleed them again.

User Avatar

Wiki User

11y ago

What else can I help you with?