Fist step is to remove the top cover over the top of the engine, and then remove the ignition coils (one for each cylinder, and then you need an extra deep slender spark plug socket to go in and remove the actual spark plug. The ignition device is approx 5" long and just pushes into the top of the spark plug.
the answer if for suzuki sport 1.8L (you forgot to say motor type)
the 1.6L vastly more common
you twist the spark plug wire boot on to of spark plug , this is on top of valve
cover.
then pull
then out comes boot and wire
then you attach a spark plug socket to your 3/8" driver ratchet
then blow out the spark plug well with shop air so sand dont fall into engine.
if oil is inside well the Valve cover gasket is bad.
then unscrew the spark plug CCW
then with a 1/4" id rubber hose fish the spark out of hole.
some sparkplug sockets have rubber plug retainers and some times works.
how to change front bumper in 1996 Suzuki sidekick sport
I have a 1998 Suzuki Sidekick JX 4X4 4 Doors, How do I set the timing? Please show me the steps thank you.
What is the spark plug gap for a 1996 suzuki gsxr 750?
The 1996 Geo Tracker and the 1996 Suzuki Sidekick are essentially the same vehicle, as the Tracker is a rebadged version of the Sidekick. Both were produced during a partnership between General Motors and Suzuki and share similar designs, platforms, and components. However, there may be minor differences in trim levels and available features due to branding and market positioning. Overall, they offer similar performance and functionality.
Because of an electric fault
Mounted on rear of fuel tank.
The factory service manual for 1996 Sidekick/Tracker defines it as: Total Toe................0.16 to 0.48 Degrees
un push the button on the shift console. done.
If it is the same plug every time, I would say the plug or wire is grounding out some where. Try replacing the plug the the wire.
To fix the horn on a 1996 Suzuki Sidekick, first, check the fuse and replace it if it's blown. Next, inspect the horn itself and the wiring for any damage or loose connections. If the horn is faulty, you can replace it by disconnecting the old horn and installing a new one, ensuring proper connections. Finally, test the horn by honking the horn button to ensure it's functioning correctly.
To replace the front wheel bearing on a 1996 Suzuki Sidekick 4x4, start by loosening the lug nuts and lifting the vehicle with a jack, then secure it on jack stands. Remove the wheel, brake caliper, and rotor to access the hub assembly. Next, detach the hub assembly from the steering knuckle, take out the old bearing, and press in the new bearing. Reassemble the hub, rotor, caliper, and wheel, making sure to torque all bolts to the manufacturer's specifications.
Locate the camshaft sensor in your car. Disconnect the electrical plug on the sensor. Remove the bolt that holds it in place. Twist the the sensor to remove it and place in the new one.