answersLogoWhite

0

remove negative battery cable,jack up truck and remove front passenger tire,easier to get to,its next to oil filter,remove ignition wire from starter,remove positive battery cable from starter,remove 2 bolts holding starter on to engine,remove starter,installation is same as installing.g0ood luck.

User Avatar

Wiki User

15y ago

What else can I help you with?

Related Questions

How long does it take to replace a fuel pump on a 1996 Nissan 4-cylinder pickup?

2 hours.


How do you change a starter motor 1996 Nissan pickup?

take the passanger side tire off it on the tranny 2 blots hold it on


Where is the starter on a Nissan 200sx 1996 located at?

Where is the starter to a Nissan 200sx


How do you replace starter on a 1996 Nissan 200sx ser?

To replace the starter on a 1996 Nissan 200SX SE-R, first disconnect the negative battery terminal to ensure safety. Then, locate the starter, which is typically found on the lower part of the engine near the transmission. Remove the mounting bolts and electrical connections from the old starter, then install the new starter by reversing the process. Finally, reconnect the battery terminal and test the starter to ensure proper function.


How do you turn back an odometer on a 1996 Nissan pickup?

you cant.


What could cause the lose of horse power to a 1996 Nissan pickup?

my 1996 Nissan pick up doesn't have horse power


Where is the horn located on a 1996 Nissan pickup?

under front bumber.


Does a 1996 Nissan pickup with a four cylinder have a timing chain?

yes,


1996 Nissan pickup engine oil capacity?

3 qrts


Where is the carbon canister on a 1996 Nissan pickup?

on the right side in front


Will a 1996 Nissan pickup transmission fit in a 1990 Nissan pickup?

It'll fit, but it probably won't work very well, as a 1996 transmission would be wholly electronic, and the 1990 transmission would not.


Can you replace a starter for a 1996 Nissan Pathfinder yourself with a kit or should you get someone else to do it?

Its a difficult job and you should get a technician to do it, If this is your first starter it will not be easy! there are clearance issues aswell as knuckle busters!