I just did this job on a 1992 Tracer, there probably haven't been too many changes over one model year.
First, take out the four 12mm bolts that hold the steering column up, let the steering wheel drop down into your lap. Take out the trim panel screws for the panel around the instrument cluster (you'll need a Torx bit). Disconnect any electrical connectors from that trim panel (I had two), and remove the panel. The instrument panel is held in with 4 Torx screws, same size as the trim panel. Next, disconnect the speedometer cable from the transmission. The connector is between the engine and the firewall, and is held in with a metal clip. Pull the speedo cable through the firewall, and the instrument cluster will push right out of the dash. Don't pull too far, you just need a little space to reach the light bulbs.
instrument panel or controls?
The instrument cluster needs to be removed to get at the bulbs.
remove dash replace bulb(instrument cluster)
If you mean daytime running lights, then probably not unless it's from Canada.
The entire instrument cluster must be remove to replace lamps. If equiped with Electronic cluster, it might be better to take it to the dealer.
Check bulbs Check Fuse Check stop light switch
you take apart the dash and get to the instrument panel. then you take the instrument panel out and on the back of the panel you'll will see the lights
Assuming it is the same as the 1998 Mercury Tracer : The fog light switch is on the turn signal lever , next to the head light switch * you probably need to have your head lights on low beam
Check fuse Check operation of door switches Check operation of headlight switch
replace it
How to replace intrument panel lights on 2002 cadillac escalade
you could have a short between the two.