0
To replace the knock sensor on a 1999 Nissan Quest, first, disconnect the battery to ensure safety. Then, locate the knock sensor, which is typically situated on the engine block. Remove the electrical connector and unbolt the sensor using the appropriate socket or wrench. Install the new sensor, reconnect the electrical connector, and reattach the battery before starting the engine to check for proper operation.
What else can I help you with?
Where is the knock sensor located in Nissan quest 2000 and how to replace it?
I AM GETTING A OBD CODE ERROR FOR MY 2000 NISSAN QUEST , PO141 AND PO325 ??? HOW DO I FIX IT..
What gaskets are needed to replace the knock sensor on a Nissan Frontier?
how many gaskets and which ones are needed when you replace the knock sensor on a Nissan frontier w/a 3.3l v6 engine?
Where is the knock sensor in a 97 Nissan Pathfinder and how can you replace it?
The knock sensor for most Nissan V6 engines is located directly under the intake manifold. So to replace it, you have to remove the intake manifold. Good Luck.
What is the cost to replace a knock sensor on a Nissan Altima?
If just the knock sensor need to be replaced. I would say no more than $150.00
How do you replace the knock sensor in a 1999 Nissan Quest?
With mucho effort, that's how. The sensor is behind the intake manifold, throttle body ect, all of which must be removed. Labor alone will be 5-6 hundred , knock sensor another 150 or so. Good luck.
Where is the knock sensor on 98 Nissan Quest?
The knock sensor on a 1998 Nissan Quest is also located under intake manifold and yes alot of work but can be done in a day. 120 dollar part and 500 labor at garage but for u at home mechanics just a simple side project.
Is there the same degree of difficulty in replacing a knock sensor on a 96 Nissan maxima as in the 96 quest?
Never mind, I got my answer.
1997 Nissan maxima where does a knock sensor go?
the Knock sensor is located behind the Harmonic balancer pulley. on the bottom sidethe sensor is $95.00 remove the lock down screw unplug and replace
Where is the knock sensor on a 99 Nissan Quest?
It is behind the intake manifold on the left side of the engine. It will take almost 6 hours to replace this cheesy part ($120) and cost about $500 in labor alone.
Where is the harness for the knock sensor on a 97 Nissan Quest?
On a 1997 Nissan Quest, the harness for the knock sensor is typically located on the engine block, near the intake manifold. You may need to remove the intake manifold to access the knock sensor more easily, as it is often positioned underneath it. The wiring harness should be connected to the sensor itself, which is usually found on the side of the engine. Always consult a repair manual for detailed diagrams and procedures specific to your vehicle.
Where is the knox sensor located on a 95 Nissan maxima?
the knock sensor is located under the intake manifold, with a flash light you can see it however you have to remove the intake manifold to replace the knock sensor , also you will need to replace the intake gasket set as well!
How do you replace the knock sensor on a 1999 Nissan maxima with a 3liter 6 cylinder?
You don't. You buy a new car.
