To replace the passenger side headlamp bulb on a 2002 Civic DX, first, open the hood and locate the headlamp assembly. Remove the plastic cover by unclipping it, then disconnect the electrical connector from the bulb. Twist the bulb socket counterclockwise to release it, replace the old bulb with a new one, and reassemble by reversing the steps. Make sure the new bulb is properly seated and reconnect the electrical connector before closing the hood.
Remove bolt on top of headlamp assembly. Gently pry and pull assembly straight out. Bulb can now be acessed.
To replace the headlamp in a 2002 Mercedes C180, first open the hood and locate the headlamp assembly. Disconnect the electrical connector by pressing the tab and pulling it off. Next, remove the retaining clips or screws securing the headlamp assembly and gently pull it out. Replace the old bulb with a new one by twisting it counterclockwise, then reassemble everything by reversing the steps.
how do you replace a taillight on a Honda 2002 Civic?
The 2002 Honda Civic EX engine uses coil-on-plug. There are no sparkplug wires.
Take it to a dealer
where are the bolts?
To replace a headlight on a 2002 Honda Civic first prop the hood open. Locate the headlight housing inside the engine compartment. Find the bulbs and remove them. Install the new bulbs.
The resistor is either located on the firewall close to the alternator or, remove the passenger headlamp and it will be located behind the horns or horn depending on your year.. The newer models should have it located on the firewall and earlier models will have it behind the passenger side headlamp..
The passenger headlight on a 2002 Honda Civic is held on by mounting brackets. Remove the bolts from the mounting brackets and pull the headlight off. Be sure to disconnect the wire harness for the lights.
Take it to the dealer.
Driver side is 21 inches Passenger side is 19 inches
Grounds for a headlight on a 2002 Honda Civic are found stemming from the wiring of the lights themselves. To replace a ground remove the old wire and solder on a new one.