To replace the turn signal combination switch in a Toyota Sienna, first disconnect the negative battery terminal to ensure safety. Remove the steering wheel cover and the airbag (if applicable) by unscrewing any fasteners and carefully disconnecting the airbag connector. Next, take out the screws securing the combination switch and disconnect its wiring harness. Finally, install the new switch by reversing the steps, ensuring all connections are secure before reassembling the steering components.
Check fuse or turn signal flasher
in the steering driver under your knee left side
yes, try a junk yard before going to a Toyota dealer
No
The flasher for a Toyota is located high on the firewall behind the dashboard. It can easily be seen by shining a flashlight upward underneath the dashboard
The flasher for a Toyota is located high on the firewall behind the dashboard. It can easily be seen by shining a flashlight upward underneath the dashboard
it is in taylorville
The flasher on a 99 Toyota Sienna should be beside the instrument panel fuses under the steering column. You will probably have to remove the driver's side knee bolster to get at it, which is kind of a pain.
a Phillips head screw driver
The turn signal flasher is a three prong plug in on a Toyota Rav4. It is located under the dash on the driver's side of most Toyota vehicles. Take the old plug out and insert the new one.
The trip odometer switch on the odometer itself is the dimmer on Toyota Sienna. If you turn this switch all the way to the left your panel would become dark. Simply turn the switch to the right and all panel lights would come on. I had a similar problem and the manual bailed me out.
You need to replace the speed sensor. It sends a signal to the speedometer and also sends a signal to the transmission on when it should shift.