Should be 2 black screws just under the top middle AC vents and 2 more under the cup holder. If you have a standard, make sure to move she shifter boot. (Don't break the clips like I have done) Take off the whole plastic panel in the middle. Make sure to unplug the hazards and defroster. If the car has been in a warmer climate, the AC vents and adjustments may come with the panel. Make sure to separate them. But mostly, just don't try to force anything as something WILL break.
Make sure to have the right wireing harness for your car. You can buy a new one and Wal-mart. Buy some crimps and a crimper while you're at Wal-mart. Take out the onld stereo and connect all the wires with your new wireing harness and stereo (It;s all color coded and should have labels as well). make sure to turn on the power and test it before you put everything back together as you will get pissed when you've done this 3 times and stereo doesn't work.
loosen adjuster bolts and take off belt......
bring it to transmission shop
about 3,000 lbs
yes the trans is the same in all 91-94 for the 1.6L motor
Tighten it up!!
yes
Behind the water pump
The flasher unit on a 1992 Nissan Sentra is located under the dash, near the hood release. It sends an intermittent signal to the turn lamps to trigger the familiar flashing.
The 1992 Nissan modulator valve can be found on the firewall in the engine compartment. The valve will be on the drivers side of the firewall.
12 Gallons is the fuel capacity
I have a 1994 Sentra, and the relay is inside the steering wheel assembly, soldered onto a circuit board.
I am replacing my radiator support in my 93 Nissan sentra SE-R this is the best i have found to do the job. i am using mig welder also to replace the welds. go to this link ---> http://www.goodwrench.com/gmgoodwrenchjsp/gmspo/Cadillac/Eldorado/1992-1999/02_Radiator_Support_Assembly.pdf