answersLogoWhite

0

It is in the distributor housing. You will have remove the distributor cap held on by 3 phillips screws. You can take off the distributor wires but it probably is not necessary. If you do be sure to mark where they go before you reconnect them. You can remove the air filter cap to give you a little more room to work. Next you will have to remove the side screw that holds the distributor coil in. Disconnect all the wires to the coil then pull it out. The TDC sensor should be inside the distributor housing and will have some wires leading to a harness attached to it.

User Avatar

Wiki User

13y ago

What else can I help you with?

Related Questions

Need instructions on 1997 Honda crv abs sensor replacement on the rear end?

The instructions to replace a Honda CR-V ABS wheel sensor is available in the service manual. If you do not own a manual, it can be obtained from Honda upon request.


Where is oil pressure sensor located on 1997 Honda Civic EX 1.6L?

where the oil pressure sensor located on 1997 Honda Civic EX 1.6L


Where is the exact location of a speed sensor on a 1997 Honda Accord?

The exact location of the speed sensor on a 1997 Honda Accord is on the very top of the transmission. There is a plug in, electronic speed sensor in this location.


Where is the turbine imput sensor it on a 1997 Honda Accord?

There is no turbine on a Honda Accord.


How do you avoid crank sensor on 1997 Honda Accord?

Avoid the crank sensor?


How to replace a water pump on a 1997 Honda Accord?

where is the water pump located on 1997 honda accord


How do you replace the dimmer switch in a 1997 Honda Accord?

how to change dimmer switch on 1997 Honda accord


How do you replace engine coolant sensor on a 1997 Honda CR-V?

To replace the engine coolant temperature sensor on a 1997 Honda CR-V, first, ensure the engine is cool and disconnect the negative battery terminal. Locate the sensor, typically found near the thermostat housing, and unplug the electrical connector. Use a wrench to unscrew and remove the old sensor, then install the new sensor by threading it in and securing it. Reconnect the electrical connector and the battery terminal before checking for leaks and proper operation.


How do you replace the camshaft position sensor on a 1997 Plymouth voyager 3 L?

how do you replace the camshaft position sensor on a 1997 plymouth voyager 3l


You have a 1997 Honda Civic EX how long would it take to replace the starter?

Where is the starter on a 1997 Honda Civic?


How do you replace the wheel bearing on a 1997 Honda Accord?

If you


How do you make a crankshaft position sensor work on a 1997 Honda passport with a 1995 block and 1997 heads?

To make a crankshaft position sensor work on a 1997 Honda passport with a 1995 block and 1997 heads will take a lot of work. You will have to redo everything under the hood.