How do you reprogram an Astrostart aka astroflex model 1105 remote?

Answer 1

THE REMOTE CONTROL

Your remote control has been designed to fit the natural contours of your hands so that it is easier to use. It works off three long-life lithium batteries.

It can control two vehicles separately. Up to four remote controls can be assigned to your vehicle. See your dealer for replacement batteries or additional remote controls.

NOTE: The range of your remote control can be affected by a weak battery, interference from nearby metal structures, hydro poles, or crowded parking lots.

USING YOUR REMOTE CONTROL

Your remote control can transmit on two different channels, allowing control of two separate vehicles.

Only the "Panic" command is transmitted on both channels simultaneously (6-button remote only).

Audible (piezo) and visual (LED) confirmations are emitted with the 6-button remote while the 5-button remote allows only visual confirmations.

CHANNEL 1:

CHANNEL 2:

To transmit a command on channel 1, press desired button for two seconds.

To transmit a command on channel 2, press desired button, then as soon as a tone is heard or that the LED flashes once, release the button for a moment then press it again and hold down for two seconds.

A command will not be executed if you do not press button long enough.

Only one command is transmitted even when a button is pressed for more than two seconds, except for the "Panic" button, which repeats command as long as button is pressed.

The remotes shown may differ from the one(s) included in the kits.

BATTERY REPLACEMENT

Your remote works off three 3-volt lithium CR-2016 batteries or equivalent.

We strongly recommend that you keep a replacement set in your glove compartment.

To replace the batteries, remove screw on back of remote case, remove old batteries and replace with new ones. Make sure that batteries point the right way; see illustration opposite.

A pictogram in the bottom of the case shows correct battery orientation.

CODE LEARNING OF ADDITIONAL TRANSMITTER(S)

Four different remote controls can be programmed for a given vehicle. If a fifth remote is added, the first remote is deleted. Note: When the first code learning command is sent, all the old codes are cleared out. therefore if you want to add a new remote, all the old ones must be reprogrammed as well.

One or more remote transmitters can be added. To do this, the programming is accessed as follows:

􏰀 Open hood

􏰀 Place key in the ignition and turn to the RUN position

􏰀 Apply the brakes once

􏰀 You now have 10 seconds to turn the key from the RUN to the OFF position 3 times.

􏰀 If this sequence is correctly carried out, the control module flashes parking lights (4 flashes). You may then

proceed to the next step.

􏰀 Press the button on the new remote control. When access code of new remote control is memorized, the control module will confirm with flashing parking lights (1 flash).

􏰀 Repeat the above procedures for each remote control that has to be programmed (up to 4 remotes).

􏰀 Apply the brakes.

New remote(s) is (are) now added to the system.