The maintenance light can be reset by pressing the red reset button on the right side below the ignition area, pass the panel.
If you don't mind looking under the steering column, you should be able to see it.
there is a little switch under the dashboard on the drivers side under the steering wheel just flip it and it should go off
You will find a switch under the steering wheel area. It may be a black retangular plastic unit, with a blue push switch. In order to turn off the Maintenance Required signal, you must first, start your car on, then click the switch a couple of times until the Maintenance Required signal turns off. If you can't find it by touch, find it using a flashlight.
How to reset maintenace light on 1999 acura t l 3.2
The easiest way to reset the check engine light on a 1995 Acura Integra is to unhook the battery for a few minutes. If the light is still on after hooking it up again, there is probably still a problem that needs to be fixed with the engine.
To reset the maintenance light on a 2011 Acura TL, turn the ignition to the "ON" position without starting the engine. Press the "Menu" button on the dashboard, navigate to "Vehicle Settings," and select "Maintenance Info." From there, choose "Reset" for the maintenance reminder you wish to clear. Finally, confirm the reset, and the maintenance light should turn off.
To reset the maintenance light on a 2009 Acura MDX, start by turning the ignition to the "ON" position without starting the engine. Press the "Menu" button on the dashboard, navigate to "Vehicle Settings," and select "Maintenance Info." From there, choose "Reset" to clear the maintenance light. Turn off the ignition, and then start the vehicle to ensure the light is reset.
i dont know how
I have a Acura Integra LS 1995 with an Acura Stereo, I have the Code but I can Not reset it , what are the steps to reset it? please help me ...
Just hold the trip reset button until the light go off,it will flashe and then come off
There is a small square button underneath the dash just to the right of the steering collumn. With the key in the ignition, in the off position, press the button for 7-10 seconds, then turn the key to ACC. This should reset the maintenance required light. It is a gimmick to get you to take your vehicle to the dealership so they make money off of you for resetting it.
Usually your oil needs changing. You have to reset the light yourself. Look in manual it will show how to reset it.
Press and hold the select AND reset buttons at the same time. Turn ignition switch to on and wait maybe 10 seconds until the maintenance light goes out.
Turn key to position 2 and hold select and reset together for 10 secounds
i only want to repair my car without taking it in to the dealership, thank you