Depending on whether that's a light duty or medium-to-heavy duty Isuzu truck, you either have an OBD-1 connector, or you have an SAE J1708 connector.. if you have OBD-1, you're out of luck... that connector isn't available for the ProLink IQ. If you have a 1708 connector, you would ideally first fix the fault which caused the code, then choose "clear all DTCs" from the menu.
The only way to reset the sensor light on a 1985 Nissan pickup truck is to disconnect the sensor wiring. After 60 seconds, put the wiring back in place.
map sensor or a bad vacum leak
how do I remove the water pump from my 1990 Isuzu truck?
Isuzu NPR is a truck. It takes diesel fuel and is a low cab forward truck.
The Isuzu Hombre and S10 were built on the same platform, but they weren't 100% identical.
It depends on the size of the Isuzu truck you are purchasing. For example, the N series Isuzu trucks carry 7,000 - 12,200 kilograms, depending on the model. When looking at a specific Isuzu truck, ask the dealer or owner what the GCM of the truck is, this will be the amount it can carry.
the oil filter on a 1994 Isuzu truck is located just below the a/c/ compressor, you will have to get under the truck from the front to see it.
Isuzu actually does not produce trucks these days, though used trucks can be purchased on the used truck markets. The trucks were reviewed as being neither outstandingly good nor bad (http://trucks.reviewitonline.net/isuzu-trucks/).
how many degrees do you set an injector pump of 4hf1 isuzu truck
Under the truck in the frame rail.
First off repair the problem that set the light or it will just come back on. You can try disconnecting the negative battery cable for 5 minutes. If that does not work you will need to have it reset with a OBD2 scan tool.
It's a 2001 Isuzu medium duty truck.